Teac P-55 instruction manual Choosing Adequate Location

Page 10

SECTION 4 : Choosing Adequate Location

WARNING

Areas indicated by the hazardous heat warning label are very hot while the power is turned on or just after turning off the power.

The temperature of the ribbon cartridges reaches about 30 °C to 35 °C while the printer is running or right after the power is shut off. On such conditions, the heat cover is at a temperature of about 74 °C to 80 °C. Touching the heat cover or around the cover may burn your skin or injure you.

To cool the printer to 30 °C or below, leave it as it is for about 40 minutes after switching off the power.

WARNING

Do not put your fingers or sleeves close to the tray sliding in or out. They can be got in, possibly causing injuries.

CAUTION

Never switch on power to the P-55 without removing shipping protection materials. Otherwise, failures may result.

10

Image 10
Contents Disc Label Printer Table of Contents Important Safety Instructions Important Safety Instructions Features IntroductionUnpacking and Inspection Blank media CD-R 10-pack of discs Printer cableIdentifying the Parts Exhaust Fan on the right sideStatus AUX Connector optional Choosing Adequate Location Choosing Adequate Location Installing/Removing Shipping Protection Materials Setting the Parallel Interface Mode on the PC Installing the Label Editor SetupInstalling the Label Editor Connecting PC to P-55 ConnectionsA C Control Panel Features Selecting USB / Parallel Port L e c tIndicating Operation State Preheating heatrollerInstalling the Printer Driver Window Please wait while the wizard installsStandard Mode Error Messages Explained Error Message Description Corrective ActionFor the contact details, see Contact If the shaft is erroneously protruding, place the ribbon Check the shaft flange How to Load a Ribbon Loading RibbonsLoading Ink Ribbon Loading Ribbons Loading Re-transfer Ribbon Turn the take-up shaft clockwise to take up ribbon slack Loading Ribbons Checking the Remaining Ribbon Amount Guide Pins Loading Print MediaGetting Label Print Job Started Getting Label Print Job StartedGetting Label Print Job Started Click OK When the process is completed, the tray slides out Print to file Supplementary explanationCorrecting for displacement and hue shift between colors Correcting for displacementClick Repeat on the Maintenance tab Getting Label Print Job Started Correcting for hue shift between colors Correcting for aspect ratio Getting Label Print Job Started Beware Point to Start, Settings and then Printers Removing Disc Label Editor and Printer DriverSelect File and then Server Properties Removing Disc Label Editor and Printer Driver Select Add or Remove Programs Removing Disc Label Editor and Printer Driver Uninstalling the P-55 related information Maintenance Cleaning the cooling fan filter every half year Periodic Checks and Maintenance by Service PersonnelShipping Ribbon setPrinter SpecificationsGeneral External Dimensions Options Product Information Teac America, Inc Contact InformationTechnical Support Teac America, Inc. Dspd Technical Support