Teac P-55 instruction manual Correcting for aspect ratio

Page 43

SECTION 14 : Getting Label Print Job Started

3) Correcting for aspect ratio

1)Place a medium on the tray and click Print next to Aspect ratio on the Maintenance tab.

2) The P-55 starts printing the first test pattern.

*The first test pattern is printed as shown on the left.

3)Take out the medium from the disc tray. Then, with the medium rotated counterclockwise by 90 degrees, place the medium back into the tray so that the two black printed areas on the medium are set toward the printer side and aligned horizontally

as shown by the arrows.

*Move the medium to the right as shown by the red thin arrows to bring the hold pins located into the center of the tray into contact with the left side of the center spindle hole of the medium.

4) Click Repeat on the Maintenance tab.

43

Image 43

Contents Disc Label Printer Table of Contents Important Safety Instructions Important Safety Instructions Introduction FeaturesBlank media CD-R 10-pack of discs Printer cable Unpacking and InspectionExhaust Fan on the right side Identifying the PartsStatus AUX Connector optional Choosing Adequate Location Choosing Adequate Location Installing/Removing Shipping Protection Materials Setting the Parallel Interface Mode on the PC Setup Installing the Label EditorInstalling the Label Editor Connections Connecting PC to P-55A C Control Panel Features L e c t Selecting USB / Parallel PortPreheating heatroller Indicating Operation StateWindow Please wait while the wizard installs Installing the Printer DriverStandard Mode Error Message Description Corrective Action Error Messages ExplainedFor the contact details, see Contact If the shaft is erroneously protruding, place the ribbon Check the shaft flange Loading Ribbons How to Load a RibbonLoading Ink Ribbon Loading Ribbons Loading Re-transfer Ribbon Turn the take-up shaft clockwise to take up ribbon slack Loading Ribbons Checking the Remaining Ribbon Amount Loading Print Media Guide PinsGetting Label Print Job Started Getting Label Print Job StartedGetting Label Print Job Started Click OK When the process is completed, the tray slides out Supplementary explanation Print to fileCorrecting for displacement Correcting for displacement and hue shift between colorsClick Repeat on the Maintenance tab Getting Label Print Job Started Correcting for hue shift between colors Correcting for aspect ratio Getting Label Print Job Started Beware Removing Disc Label Editor and Printer Driver Point to Start, Settings and then PrintersSelect File and then Server Properties Removing Disc Label Editor and Printer Driver Select Add or Remove Programs Removing Disc Label Editor and Printer Driver Uninstalling the P-55 related information Maintenance Periodic Checks and Maintenance by Service Personnel Cleaning the cooling fan filter every half yearRibbon set ShippingPrinter SpecificationsGeneral External Dimensions Options Product Information Teac America, Inc Contact InformationTechnical Support Teac America, Inc. Dspd Technical Support