Teac P-55 instruction manual Loading Print Media, Guide Pins

Page 33

SECTION 13 : Loading Print Media

NOTES

-The P-55 supports a standard medium (12-cm diameter) only. Mini media (8-cm diameter) and odd-shaped media are not supported.

-With the P-55 you need to use the TEAC-specified media exclusively. Use of commercially available media for inkjet printers might inevitably result in poor quality output.

1)Press the LOAD/EJECT button to let the disc tray slide out.

2)Place a medium on the tray, label print side up, data committing side down.

3)Making sure that the medium is correctly placed on the tray, press the LOAD/EJECT button to let the tray slide in.

4)When the tray has fully slid in, the READY lamp will light up. Then, let the printing process start through graphics software in use.

NOTES

-Do not place any objects other than the right print media.

-Load only one medium. Loading multiple media might produce trouble.

-Load a medium only when the tray fully slides out and stops.

-Make sure that the medium does not sit on the guide pins.

Guide Pins

-Clean dust off the medium surface before printing.

(Printing on the medium with dust attached on the surface may deteriorate the original print quality.)

WARNING

-Do not touch the die-cast alloy part of the tray, which causes heat buildup.

-Do not put your fingers or sleeves close to the tray that is sliding in or out. They can be got in, possibly causing injuries.

33

Image 33

Contents Disc Label Printer Table of Contents Important Safety Instructions Important Safety Instructions Introduction FeaturesBlank media CD-R 10-pack of discs Printer cable Unpacking and InspectionExhaust Fan on the right side Identifying the PartsStatus AUX Connector optional Choosing Adequate Location Choosing Adequate Location Installing/Removing Shipping Protection Materials Setting the Parallel Interface Mode on the PC Setup Installing the Label EditorInstalling the Label Editor Connections Connecting PC to P-55A C Control Panel Features L e c t Selecting USB / Parallel PortPreheating heatroller Indicating Operation StateWindow Please wait while the wizard installs Installing the Printer DriverStandard Mode Error Message Description Corrective Action Error Messages ExplainedFor the contact details, see Contact If the shaft is erroneously protruding, place the ribbon Check the shaft flange Loading Ribbons How to Load a RibbonLoading Ink Ribbon Loading Ribbons Loading Re-transfer Ribbon Turn the take-up shaft clockwise to take up ribbon slack Loading Ribbons Checking the Remaining Ribbon Amount Loading Print Media Guide PinsGetting Label Print Job Started Getting Label Print Job StartedGetting Label Print Job Started Click OK When the process is completed, the tray slides out Supplementary explanation Print to fileCorrecting for displacement Correcting for displacement and hue shift between colorsClick Repeat on the Maintenance tab Getting Label Print Job Started Correcting for hue shift between colors Correcting for aspect ratio Getting Label Print Job Started Beware Removing Disc Label Editor and Printer Driver Point to Start, Settings and then PrintersSelect File and then Server Properties Removing Disc Label Editor and Printer Driver Select Add or Remove Programs Removing Disc Label Editor and Printer Driver Uninstalling the P-55 related information Maintenance Periodic Checks and Maintenance by Service Personnel Cleaning the cooling fan filter every half yearRibbon set ShippingSpecifications PrinterGeneral External Dimensions Options Contact Information Product Information Teac America, IncTechnical Support Teac America, Inc. Dspd Technical Support