Teac P-55 instruction manual Getting Label Print Job Started

Page 41

SECTION 14 : Getting Label Print Job Started

8) After the second pattern has been printed, take out the medium.

NOTE

-The upper and lower test patterns relative to the center hole are the same, and so are the left and right test patterns.

-The upper and lower scales relate to vertical adjustment and the left and right scales relate to horizontal adjustment.

9)Pairs of longer and shorter lines are printed along the vertical and horizontal scales. Determine which pair of longer and shorter lines is aligned (or which pair of lines has the slightest displacement between), enter the corresponding values in the Horizontal and Vertical boxes on the Maintenance tab, and click OK. (In our example, you need to enter 8 in the Vertical box.)

41

Image 41

Contents Disc Label Printer Table of Contents Important Safety Instructions Important Safety Instructions Introduction FeaturesBlank media CD-R 10-pack of discs Printer cable Unpacking and InspectionExhaust Fan on the right side Identifying the PartsStatus AUX Connector optional Choosing Adequate Location Choosing Adequate Location Installing/Removing Shipping Protection Materials Setting the Parallel Interface Mode on the PC Setup Installing the Label EditorInstalling the Label Editor Connections Connecting PC to P-55A C Control Panel Features L e c t Selecting USB / Parallel PortPreheating heatroller Indicating Operation StateWindow Please wait while the wizard installs Installing the Printer DriverStandard Mode Error Message Description Corrective Action Error Messages ExplainedFor the contact details, see Contact If the shaft is erroneously protruding, place the ribbon Check the shaft flange Loading Ribbons How to Load a RibbonLoading Ink Ribbon Loading Ribbons Loading Re-transfer Ribbon Turn the take-up shaft clockwise to take up ribbon slack Loading Ribbons Checking the Remaining Ribbon Amount Loading Print Media Guide PinsGetting Label Print Job Started Getting Label Print Job StartedGetting Label Print Job Started Click OK When the process is completed, the tray slides out Supplementary explanation Print to fileCorrecting for displacement Correcting for displacement and hue shift between colorsClick Repeat on the Maintenance tab Getting Label Print Job Started Correcting for hue shift between colors Correcting for aspect ratio Getting Label Print Job Started Beware Removing Disc Label Editor and Printer Driver Point to Start, Settings and then PrintersSelect File and then Server Properties Removing Disc Label Editor and Printer Driver Select Add or Remove Programs Removing Disc Label Editor and Printer Driver Uninstalling the P-55 related information Maintenance Periodic Checks and Maintenance by Service Personnel Cleaning the cooling fan filter every half yearRibbon set ShippingGeneral SpecificationsPrinter External Dimensions Options Technical Support Teac America, Inc. Dspd Technical Support Contact InformationProduct Information Teac America, Inc