Taylor CONROE1333-DVI/H DVMT/FIXED Memory, OnBoard HD Audio, Front Panel Control, CD-In

Page 34

DVMT/FIXED Memory

You are allowed to adjust the shared memory size in this item if you set DVMT Mode Select as [DVMT Mode]. Configuration options: [64MB], [128MB] and [Maximum DVMT].

OnBoard HD Audio

Select [Auto], [Enabled] or [Disabled] for the onboard HD Audio feature. If you select [Auto], the onboard HD Audio will be disabled when PCI Sound Card is plugged.

Front Panel Control

Select [Auto], [Enabled] or [Disabled] for the onboard HD Audio Front Panel.

CD-In

Use this item to enable or disable CD-In of OnBoard HD Audio. If you plan to use this motherboard to submit Windows® VistaTM logo test, please disable this option.

OnBoard Lan

This allows you to enable or disable the “OnBoard Lan” feature.

PCI Fix Function

This allows you to enable or disable PCI Fix Function. The default value is [Enabled]. If this item is set to [Enabled], PCI frequency can be fixed at

33.3MHz. If this item is set to [Disabled], PCI clock can be synchronized to PCIE clock.

VCCM Voltage

Use this to select VCCM Voltage. Configuration options: [High], [Middle], [Low], and [Auto]. The default value of this feature is [Auto].

VDDQ Voltage

Configuration options: [High], [Low] and [Auto]. The default value is [Auto].

3 4

Image 34
Contents ConRoe1333-DVI/H Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications See Caution ConnectorBios Feature Support CDDDRII533*, DDRII667 CPU Motherboard Layout 24.4cm 9.6HD 8CH I/O Table for Audio Output ConnectionPre-installation Precautions Screw HolesCPU Installation Page Installation of CPU Fan and Heatsink Installation of Memory Modules Dimm Dual Channel Memory ConfigurationsInstalling a Dimm Notch breakInstalling an expansion card Expansion Slots PCI, Hdmr and PCI Express SlotsDVI Graphics-HDCP card DVI Graphics-HDCP Card Installation GuideDVI-D connector DVI-D monitor DVI Graphics-HDCPWhat is HDCP? Hdcp Function with DVI Graphics-HDCP CardJumpers Setup PS2USBPWR1Onboard Headers and Connectors IDE1USB 2.0 Headers Chassis Speaker Header Serial port Header Sataii Hard Disk Setup Guide Western DigitalHdmr Card and Driver Installation Driver Installation GuideUntied Overclocking Technology Bios Menu Bar Main Screen Navigation KeysAdvanced Screen CPU Configuration Ratio Actual Value Ratio Cmos SettingRatio Status Enhance Halt StateIntel R SpeedSteptm tech Chipset ConfigurationConfigure Dram Timing by SPD Dram FrequencyDvmt Mode Select Dram RAS# to CAS# DelayInternal Graphics Mode Select Dram CAS# LatencyFront Panel Control DVMT/FIXED MemoryOnBoard HD Audio CD-InAcpi Configuration IDE Device Configuration IDE ConfigurationATA/IDE Configuration ATA/IDE Configuration EnhancedDMA Mode LBA/Large ModePIO Mode Block Multi-Sector TransferA.R.T PCIPnP ConfigurationPCI Latency Timer Bit Data TransferOnBoard Floppy Controller Floppy ConfigurationSuper IO Configuration Serial Port AddressUSB Configuration CPU Quiet Fan Target CPU Temperature CHardware Health Event Monitoring Screen Tolerance CBoot From Onboard LAN Boot ScreenBoot Settings Configuration Boot Up Num-LockChange Supervisor Password Main Advanced Monitor BootSecurity Screen Save Changes and Exit Load Optimal DefaultsExit Screen Discard Changes and ExitRunning The Support CD Install Operating SystemSupport CD Information Drivers Menu