Taylor CONROE1333-DVI/H PCIPnP Configuration, A.R.T, Bit Data Transfer, PCI Latency Timer

Page 38

S.M.A.R.T.

Use this item to enable or disable the S.M.A.R.T. (Self-Monitoring, Analysis, and Reporting Technology) feature. Configuration options: [Disabled], [Auto], [Enabled].

32-Bit Data Transfer

Use this item to enable 32-bit access to maximize the IDE hard disk data transfer rate.

3.3.5 PCIPnP Configuration

BIOS SETUP UTILITY

Advanced

Advanced PCI / PnP Settings

PCI

Latency Timer

[32]

PCI

IDE BusMaster

[Enabled]

Value in units of PCI clocks for PCI device latency timer register.

 

Select Screen

 

Select Item

+-

Change Option

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

PCI Latency Timer

The default value is 32. It is recommended to keep the default value unless the installed PCI expansion cards’ specifications require other settings.

PCI IDE BusMaster

Use this item to enable or disable the PCI IDE BusMaster feature.

3 8

Page 37 Page 39
Image 38
Page 37 Page 39
Contents
ConRoe1333-DVI/H Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications See Caution ConnectorBios Feature Support CDDDRII533*, DDRII667 CPU Motherboard Layout 24.4cm 9.6HD 8CH I/O Table for Audio Output ConnectionPre-installation Precautions Screw HolesCPU Installation Page Installation of CPU Fan and Heatsink Installation of Memory Modules Dimm Dual Channel Memory ConfigurationsInstalling a Dimm Notch breakInstalling an expansion card Expansion Slots PCI, Hdmr and PCI Express SlotsDVI Graphics-HDCP card DVI Graphics-HDCP Card Installation GuideDVI-D connector DVI-D monitor DVI Graphics-HDCPWhat is HDCP? Hdcp Function with DVI Graphics-HDCP CardJumpers Setup PS2USBPWR1Onboard Headers and Connectors IDE1USB 2.0 Headers Chassis Speaker Header Serial port Header Sataii Hard Disk Setup Guide Western DigitalUntied Overclocking Technology Driver Installation GuideHdmr Card and Driver Installation Bios Menu Bar Advanced Screen Navigation KeysMain Screen CPU Configuration Ratio Actual Value Ratio Cmos SettingRatio Status Enhance Halt StateIntel R SpeedSteptm tech Chipset ConfigurationConfigure Dram Timing by SPD Dram FrequencyDvmt Mode Select Dram RAS# to CAS# DelayInternal Graphics Mode Select Dram CAS# Latency Front Panel Control DVMT/FIXED Memory OnBoard HD Audio CD-InAcpi Configuration IDE Device Configuration IDE ConfigurationATA/IDE Configuration ATA/IDE Configuration EnhancedDMA Mode LBA/Large ModePIO Mode Block Multi-Sector TransferA.R.T PCIPnP ConfigurationPCI Latency Timer Bit Data TransferOnBoard Floppy Controller Floppy ConfigurationSuper IO Configuration Serial Port AddressUSB Configuration CPU Quiet Fan Target CPU Temperature CHardware Health Event Monitoring Screen Tolerance CBoot From Onboard LAN Boot ScreenBoot Settings Configuration Boot Up Num-LockSecurity Screen Main Advanced Monitor BootChange Supervisor Password Save Changes and Exit Load Optimal DefaultsExit Screen Discard Changes and ExitRunning The Support CD Install Operating SystemSupport CD Information Drivers Menu
Top Page Image Contents