Taylor CONROE1333-DVI/H user manual Serial port Header

Page 25

Serial port Header

(9-pin COM1)

(see p.10 No. 29)

1

RRXD1

DDTR#1 DDSR#1

CCTS#1

RRI#1

RRTS#1

GND

TTXD1

DDCD#1

This COM1 header supports a serial port module.

2 5

Image 25

Contents ConRoe1333-DVI/H Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Bios Feature ConnectorSee Caution Support CDDDRII533*, DDRII667 CPU 24.4cm 9.6 Motherboard LayoutTable for Audio Output Connection HD 8CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Page Installation of CPU Fan and Heatsink Dual Channel Memory Configurations Installation of Memory Modules DimmNotch break Installing a DimmExpansion Slots PCI, Hdmr and PCI Express Slots Installing an expansion cardDVI-D connector DVI-D monitor DVI Graphics-HDCP Card Installation GuideDVI Graphics-HDCP card DVI Graphics-HDCPHdcp Function with DVI Graphics-HDCP Card What is HDCP?PS2USBPWR1 Jumpers SetupIDE1 Onboard Headers and ConnectorsUSB 2.0 Headers Chassis Speaker Header Serial port Header Western Digital Sataii Hard Disk Setup GuideHdmr Card and Driver Installation Driver Installation GuideUntied Overclocking Technology Bios Menu Bar Main Screen Navigation KeysAdvanced Screen CPU Configuration Ratio Status Ratio Cmos SettingRatio Actual Value Enhance Halt StateConfigure Dram Timing by SPD Chipset ConfigurationIntel R SpeedSteptm tech Dram FrequencyInternal Graphics Mode Select Dram RAS# to CAS# DelayDvmt Mode Select Dram CAS# LatencyOnBoard HD Audio DVMT/FIXED MemoryFront Panel Control CD-InAcpi Configuration ATA/IDE Configuration IDE ConfigurationIDE Device Configuration ATA/IDE Configuration EnhancedPIO Mode LBA/Large ModeDMA Mode Block Multi-Sector TransferPCI Latency Timer PCIPnP ConfigurationA.R.T Bit Data TransferSuper IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressUSB Configuration Hardware Health Event Monitoring Screen Target CPU Temperature CCPU Quiet Fan Tolerance CBoot Settings Configuration Boot ScreenBoot From Onboard LAN Boot Up Num-LockChange Supervisor Password Main Advanced Monitor BootSecurity Screen Exit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSupport CD Information Install Operating SystemRunning The Support CD Drivers Menu