Taylor CONROE1333-DVI/H user manual Cpu

Page 9

1.3Minimum Hardware Requirement Table for Windows®

VistaTM Premium 2007 and Basic Logo

For system integrators and users who purchase this motherboard and plan to submit Windows® VistaTM Premium 2007 and Basic logo, please follow below table for minimum hardware requirements.

CPU

Celeron D 326

Memory

512MB x 2 Dual Channel (Premium)

 

512MB Single Channel (Basic)

 

256MB x 2 Dual Channel (Basic)

 

VGA

DX9.0 with VDDM Driver

 

DVI with HDCP

 

*If you use onboard VGA with total system memory size 512MB and plan to submit Windows® VistaTM Basic logo, please adjust the shared memory size of onboard VGA to 64MB. If you use onboard VGA with total system memory size above 512MB and plan to submit Windows® VistaTM Premium or Basic logo, the shared memory size of onboard VGA can be adjusted up to 128MB.

*If you plan to use external graphics card on this motherboard, please refer to Premium Discrete requirement at http://www.asrock.com

*If the onboard VGA supports DVI, it must also support HDCP function to qualify for Windows® VistaTM Premium 2007 logo.

*After June 1, 2007, all Windows® VistaTM systems are required to meet above minimum hardware requirements in order to qualify for Windows® VistaTM Premium 2007 logo.

9

Image 9
Contents ConRoe1333-DVI/H Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Bios Feature ConnectorSee Caution Support CDDDRII533*, DDRII667 CPU 24.4cm 9.6 Motherboard LayoutTable for Audio Output Connection HD 8CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Page Installation of CPU Fan and Heatsink Dual Channel Memory Configurations Installation of Memory Modules DimmNotch break Installing a DimmExpansion Slots PCI, Hdmr and PCI Express Slots Installing an expansion cardDVI-D connector DVI-D monitor DVI Graphics-HDCP Card Installation GuideDVI Graphics-HDCP card DVI Graphics-HDCPHdcp Function with DVI Graphics-HDCP Card What is HDCP?PS2USBPWR1 Jumpers SetupIDE1 Onboard Headers and ConnectorsUSB 2.0 Headers Chassis Speaker Header Serial port Header Western Digital Sataii Hard Disk Setup GuideDriver Installation Guide Hdmr Card and Driver InstallationUntied Overclocking Technology Bios Menu Bar Navigation Keys Main ScreenAdvanced Screen CPU Configuration Ratio Status Ratio Cmos SettingRatio Actual Value Enhance Halt StateConfigure Dram Timing by SPD Chipset ConfigurationIntel R SpeedSteptm tech Dram FrequencyInternal Graphics Mode Select Dram RAS# to CAS# DelayDvmt Mode Select Dram CAS# LatencyOnBoard HD Audio DVMT/FIXED MemoryFront Panel Control CD-InAcpi Configuration ATA/IDE Configuration IDE ConfigurationIDE Device Configuration ATA/IDE Configuration EnhancedPIO Mode LBA/Large ModeDMA Mode Block Multi-Sector TransferPCI Latency Timer PCIPnP ConfigurationA.R.T Bit Data TransferSuper IO Configuration Floppy ConfigurationOnBoard Floppy Controller Serial Port AddressUSB Configuration Hardware Health Event Monitoring Screen Target CPU Temperature CCPU Quiet Fan Tolerance CBoot Settings Configuration Boot ScreenBoot From Onboard LAN Boot Up Num-LockMain Advanced Monitor Boot Change Supervisor PasswordSecurity Screen Exit Screen Load Optimal DefaultsSave Changes and Exit Discard Changes and ExitSupport CD Information Install Operating SystemRunning The Support CD Drivers Menu