Taylor CONROE1333-DVI/H Security Screen, Main Advanced Monitor Boot, Change Supervisor Password

Page 43

3.6 Security Screen

In this section, you may set or change the supervisor/user password for the system. For the user password, you may also clear it.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security

Exit

Security Settings

Supervisor Password

: Not Installed

User Password

: Not Installed

Change Supervisor Password

Change User Password

Install or Change the password.

 

Select Screen

 

Select Item

Enter

Change

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

4 3

Image 43
Contents ConRoe1333-DVI/H Disclaimer Copyright NoticeContents Software Support Introduction Package ContentsSpecifications Support CD ConnectorBios Feature See CautionDDRII533*, DDRII667 CPU 24.4cm 9.6 Motherboard LayoutTable for Audio Output Connection HD 8CH I/OScrew Holes Pre-installation PrecautionsCPU Installation Page Installation of CPU Fan and Heatsink Dual Channel Memory Configurations Installation of Memory Modules DimmNotch break Installing a DimmExpansion Slots PCI, Hdmr and PCI Express Slots Installing an expansion cardDVI Graphics-HDCP DVI Graphics-HDCP Card Installation GuideDVI-D connector DVI-D monitor DVI Graphics-HDCP cardHdcp Function with DVI Graphics-HDCP Card What is HDCP?PS2USBPWR1 Jumpers SetupIDE1 Onboard Headers and ConnectorsUSB 2.0 Headers Chassis Speaker Header Serial port Header Western Digital Sataii Hard Disk Setup GuideHdmr Card and Driver Installation Driver Installation GuideUntied Overclocking Technology Bios Menu Bar Main Screen Navigation KeysAdvanced Screen CPU Configuration Enhance Halt State Ratio Cmos SettingRatio Status Ratio Actual ValueDram Frequency Chipset ConfigurationConfigure Dram Timing by SPD Intel R SpeedSteptm techDram CAS# Latency Dram RAS# to CAS# DelayInternal Graphics Mode Select Dvmt Mode SelectCD-In DVMT/FIXED MemoryOnBoard HD Audio Front Panel ControlAcpi Configuration ATA/IDE Configuration Enhanced IDE ConfigurationATA/IDE Configuration IDE Device ConfigurationBlock Multi-Sector Transfer LBA/Large ModePIO Mode DMA ModeBit Data Transfer PCIPnP ConfigurationPCI Latency Timer A.R.TSerial Port Address Floppy ConfigurationSuper IO Configuration OnBoard Floppy ControllerUSB Configuration Tolerance C Target CPU Temperature CHardware Health Event Monitoring Screen CPU Quiet FanBoot Up Num-Lock Boot ScreenBoot Settings Configuration Boot From Onboard LANChange Supervisor Password Main Advanced Monitor BootSecurity Screen Discard Changes and Exit Load Optimal DefaultsExit Screen Save Changes and ExitDrivers Menu Install Operating SystemSupport CD Information Running The Support CD