Uniden UBC 120XLT manual Setup, Charging the Battery Pack, Mounting the Flexible Antenna

Page 12

I

Setup

The USC 120XLT comes with a rechargeable

Nickel-Cadmit

Battery Pack. When

fully charged, this Battery

Pack

will

supply

up to 12 hours

of dependable use. (With the

Squelch

control

in "closed" position.)

 

I

Before using the USC 120XL T for the first time, or whenever the LOW BATTERY Indicator appears on the LCD display, you should fully charge the Battery Pack.

Note: When the Battery Pack is Iow, the Low Battery Indicator will start to blink. After about 10 minutes, the

scanner will shut itself off to prevent the battery from becoming completely discharged.

Before charging, you must first install the Battery Pack according to the steps below.

Charging the Battery Pack

1.Plug the AC Adaptor/Charger (AAD-2500U) into the

Charging Jack located on the Left side of the

UBC 120XLT . (You can use the scanner while it is charging.)

WARNING! Use only an AAD-2500U AC Adaptor/

Charger, (or one of the optional Cigarette Lighter Power Cords listed on page 26). Any

other AC Adaptor or external cord or power plug

having over-voltage or reversed polarity can

cause overheating or damage to the circuitry.L-,

2.Plug the AC Adaptor/Charger into a standard AC outlet.

To fully charge the battery, leave the Adaptor/Charger connected for 14 to 16 hours.

3.When charging is complete, disconnect the Adaptor! Charger from the AC outlet and from the Battery Pack.

Note: Disconnect the AC Adaptor/Charger from the unit during a power failure.

Mounting the Flexible Antenna

Place the end of the antenna onto the BNC connector on top of the scanner and turn clockwise until tight.

10

Page 11 Page 13
Image 12
Page 11 Page 13
Contents UBC 120XLT Precautions Table of Contents What is Searching? About Your New USC 120XLTTypes of Communication BeltClip Feature Highlights Twin Turbo Scan & Search -This lightning-fastPriority Channels You can assign one Priority Front View Squelch Control PriorityChannelIndicator- Pappears Indicates Scan Mode Indicates Search Flashes When in Turb Arch Mode Ica es Priority Scan ModeScan Mode. PR~ears on the display. While Eys toCD 1 1 Setup Charging the Battery PackMounting the Flexible Antenna Installing the Belt Clip Place the Belt Clip on Mounting area on Back~ ~ Operation Overview 1LfSCRN Search The Search function is different from ScanProgramming Channels Programming By Manual EntrySelecta frequency Press ~ to stop scanningTo program another channel, repeat the above procedures Deleti ng a Stored Freq uencyScanning To activatePriorityScan,press@. The PRIindicatorwill Scan, press @ again. The PRIindicator will disappear fromPress~ Locking Out Chan nels During scanning, you will not see locked~Weather Channel Scanning Press DAT~ to activate the Data Skip feature. The DA1A DAT~again. The DA1A indicator disappears from the displaySearch Frequency Skip Programming With SearchCare and Maintenance Replacing the Battery PackCleaning FOOlBirdies Proper Care of Your ScannerTroubleshooting ProblemsolutionYour UBC 120XL T are available from your local Uniden LC-120 UA-502 UA-502A BCK-150 OMBC120Technical Specifications Warrant~ P700 888.8888AIRWX Unidl!n@
Top Page Image Contents