Scan Mode. PR~ears on the display. While

4. Press (UGHT)to turn the display backlight ON for 15

seconds. Press (UGHT)again to manually turn the light OFF.

5.Use CVto enter the decimal point when programming a

frequency into a channel. If you make an entry error, press CVkey twice to erase the entry, and start over again.

6.There are 7 Preprogrammed weather channels Press 00 to findthe active weather channel in

your area. WXappears on the display in Weather Mode.

7.Use @ to set the limits of a range of frequencies for

Search Mode. When Search is stopped. In SCAN HOLD Mode, use this key to go down to the next channel. Use T to go down in frequency.

8.While Scanning, press @ to enter the PRIORI1Y

SCAN Mode. (PR~ears on the display.) While

Searching, press ~ (TURBO) to toggle between 100 steps and 300 steps per second. (When in TURBO SEARCH Mode, SRCHflashes on the display.)

9.Press (DELAY) to turn ON or OFF the automatic 2-second delay during scanning or searching for active frequencies. (In Delay Mode, DLY appears on the display.) In this mode, when the scanner monitors an active frequency, searching or scanning will not resume until transmission stops for 2 seconds.

10.Press and hold(LOCK). ... appears on the d\splay and

you hear two beeps. This disables the keypa~ and

	he
preventskeypad, pressany accidentaland hold (eyLOCK)ntries	disappearsTo enable\tkom the
	.
display and you hear two beeps.	\

11.NUMERIC KEYPAD - Use these keys to prog~m a channel for scanning. Also use to access a Chan 1

directly with~.	During SCAN Mode, use these	eys to
select or deselect any of the 10 memory banks. (		nly
	~
the selected bank indicator(s) appear on the displ y.)
Note: You cannot deactivate al/1 0 banks at tl/le
same time.	/

SCAN Mode. (PR~ears on the display.) While

eys to

same time.