Installing the Belt Clip |
|
|
1. Place the Belt Clip on |
|
|
the mounting area on |
|
|
the back of the |
| ~ ~ |
scanner, making sure | @ | @ |
|
| |
the holes in the clip |
|
|
line up with the |
|
|
threads in the back of |
|
|
the scanner. |
| ~ |
|
|
I
2.Insert the 2 screws into the corresponding holes and tighten.
CAUTION: Do not tighten the screws too tight. You could
damage the case or clip.
Using the Earphone
The PHONE jack at the top of the UBC 120XLT is a standard 3.5mm stereo phone jack. You can use either the supplied earphone, or a stereo headset. The output of this jack is
monaural audio, but you will hear it in both headphones of a stereo headset.
IMPORTANT!
Be sure to use only the supplied earphone, or stereo headset of the proper impedance (32ft) Use of an incorrect earphone or stereo headset may be potentially dangerous to your hearing.
WARNING:Do not plug in the earphone or head- phones before setting the Volume Control. You might experience some hearing damage if the Volume suddenly becomes too loud because of the volume Control or Squelch Control setting. This is particularlytrue of the type of earphonethat is placed in the ear canal.
11