Scanning

Note: When you turn the scanner on it will always be in SCAN Mode.

1.look at the lower left corner of the display. If SCNis not

displa~ed, press @. The UBC 120XLT should begin scanning.

2.If HOLD appears at the bottom of the display, press @ to begin scanning.

The indicators for the selected Banks (1 through 10) appear on the display. The indicator of the Bank currently being monitored flashes. While the UBC 120XL T is scanning, the word SCAN moves across the display.

Scanning stops on any active channel that is not "locked Out", and displays the Channel Number and frequency. Scanning resumes automatically after the transmission stops.

3.You can deselect any bank(s) from being scanned by entering the number of the bank. The deselected bank indicator(s) disappear from the display, and those channels will not be scanned. This procedure helps to speed up the scanning cycle.

Note: One Bank must always be active. You cannot

deactivate al/1 0 banks at the same time. If you try to deactivate all 10 Banks, Bank 1 will automatically

be active.

4.To restore any bank for scanning, just enter its number again. The bank indicator will reappear on the display.

5. To stop scanning any time, press~. (HOLD appears on the display.) The scanner remains on the displayed channel, and only the bank indicator for that channel

appears. Press @. to resume scanning.

6.When you are stopped at a channel, you can press ~ to step down a channel, or £ to step up a channel. Press

and hold either key to rapidly step through the channels.

Note: You do not skip a locked out ('UO'? channel when you use ~ or £.

-. --- .._--