2. You hear a beep, and ATT appears in the display begins flashing.
Now all incoming signal strength is reduced.
To turn RF Attenuation off, just press ATT again. The ATT icon goes out.
Setting the Delay Mode
A delay can be set for each programmed channel so that when scan or search stops on a channel there is a brief pause before the scanning cycle resumes. Delay must be set for each programmed channel and it can be set when your scanner pauses during a scan or when manual mode is selected.
Delay in Scan or Search Mode
1.Press 
or set a search range and press 
.
2.When your scanner stops on a channel that you want to delay, press 
.
displays and scanning resumes two seconds after the transmission ends.DLY
22