7.Press 
.
The next available block displays.
8.Repeat Steps 8 and 9 until you have selected a size code for each block.
For specifics about each size code, see Fleet Map Size Codes in the Appendix.
9.Press 
.
The scanner exits the Trunking Programming mode, acquires the data channel, and begins searching using the map you’ve programmed.
Note: It is required that the trunked frequency has been programmed before programming a
fleet map.
Programming a Hybrid System
A Hybrid system is simply a Type I system with some blocks designated as Type II blocks. To program a Hybrid system, follow the steps listed in Programming a Fleet Map in the previous section. However, if you want a block to be Type II, select Size Code
When you begin searching a trunking bank with a Hybrid Fleet Map, you will see both types of system Ids. That is, Type II Ids usually appear as an even number without a dash; Type I Ids appear as a three or four digit number, followed by a hyphen, followed by a one or two digit number. See page 68 for more information.
59