By default, the ZMAX-8210 CPE is Devicexxxxxx(xxxxxx represents the last 6 digits of MAC address).
No figure is allowed to represent initial.
When WINS undertakes interpreting, make sure the PC IP address need to be matched the CPE. For instance, the ZMAX-8210 is 192.168.1.1, and your PC IP should be 192.168.1. X.
Bridge and Router Mode
The ZMAX-8210 is capable of working under bridge and router modes.
Opening“IP Settings”will navigate you to the configuring mode page.
Figure 9 Configure the ZMAX-8210 to Bridge
The ZMAX-8210 provides bridge and router modes. Under the bridge mode, you are required to set IP Address, Subnet Mask, Default Gateway and Primary (Second) DNS Server. For Router mode, refer to “Set Router Mode”.
IP Address
The ZMAX-8210 provides two options of obtaining IP addresses, static IP address and dynamic address from DHCP Server.
STATIC：Manually set the ZMAX-8210 IP address subnet Mask, Default Gateway and Primary (Second) DNS Server. 255.255.255.0 is usually taken as the subnet mask.
DHCP Client：Alternatively, the ZMAX-8210 can obtain IP address subnet Mask, Default Gateway and Primary (Second) DNS Server from DHCP Server.
Note：
Chapter 3 Basic Settings | - 11 - |
