Z-Com ZMAX-8210-E, ZMAX-8210-I user manual ZMAX-8210 Wireless Parameters

If you fail to obtain IP address for the ZMAX-8210, the CPE will turn to the client address for use.

Wireless Parameters

Opening“Radio Settings can lead you to the ZMAX-8210 wireless parameters. You can set what you desire.

Figure 10 ZMAX-8210 Wireless Parameters

Base Station ID：This field allows you to enter the Base Station ID you want to connect, to establish a tie between this CPE and the Base Station.

Duplex Mode：This field allows you to have the options of TDD and HFDD modes.

Note：

Under the Duplex Mode, you are required to keep the consistency in setting between the ZMAX-8210 and the Base station.

Center Frequency：This field helps you to scan the center frequency that the linked device performs and shows the frequency in this field.

CP Size：This field displays the ratio of hardware MTU (maximum transmission unit) before rotating this device.

Bandwidth：This field provides the bandwidth when this device is undertaking tasks. You can get two options-- 3.5MHz and7MHz.

Note：

The bandwidth shall be in the complete accord between the ZMAX-8210 and the Base Station connected.

Frame Length：This field displays the frame length that the ZMAX-8210 can obtain from other

Chapter 3 Basic Settings - 12 -