Z-Com ZMAX-8210-I, ZMAX-8210-E user manual Putty Settings

Page 31

Figure 26 Putty Settings

From the “Connection”, select “SSH”; From the “Preferred SSH protocol version”, select“2”; From the “Encryption cipher selection policy”, make“3DES”the top position.

Chapter 5 Management

- 25 -

Image 31

Contents Page Bold Indicates the function, important words, and so on CopyrightManagement TroubleshootingPage ZMAX-8210 Page Introduction IntroductionAppearance Build Typical Infrastructure Key FeaturesWireless Point-to-Point Outdoors Typical Case Wireless Point-to-multipoint OutdoorsSystem Requirement Basic InstallationPackage Content Hardware InstallationGround Antenna Installation ZMAX-8210 Default Factory Settings Basic SettingsDefault Factory Settings How to Login Your ZMAX-8210 via WEB BrowserSafety Alert ZMAX-8210 General Information Device NameIP Address Bridge and Router ModeZMAX-8210 Wireless Parameters Wireless ParametersBuild the Infrastructure with WiMAX Base Station Create a Link between the ZMAX-8210 and WiMAX Base StationBasic Settings Router Mode Advanced ConfigurationAny IP Wireless Router ModeTime Server Dhcp ServerTypical Http Redirect Case Http RedirectHttp Redirect View the ZMAX-8210 Basic Information ManagementView Statistics Information Upgrade Firmware PasswordChapter Backup and RetrieveRetrieve and Backup Settings Reboot Restore Factory Default SettingsPutty Settings SSH Settings Management Why I fail to configure my ZMAX-8210？ TroubleshootingFrequently Asked Question FAQ Why my PC fails to access the internet?How I could know my PC has connected to the ZMAX-8210? Refer to Restore Factory Default SettingsZMAX-8210 Ping ZMAX-8210-I Spec Appendix a SpecificationsQAM 3/4 64QAM 3/4 ZMAX-8210-E Spec InterfaceModule ZMAX-8210-E Secure WEB Management Yes Interface Technical Terms Appendix B Technical TermsDevice and other devices Ascii Appendix C AsciiAppendix C Ascii Appendix D SSH Settings TrapServer Address Read Snmp Readcommunity Community Appendix D SSH Settings