Z-Com ZMAX-8210-I, ZMAX-8210-E user manual Dhcp Server, Time Server

Page 23

DHCP Server

Under the router mode, the ZMAX-8210 can also serve as a DHCP server, responsible for assigning IP addresses to the devices connected to the infrastructure.

From the“IP Settings”choose“Router”. The way to assign IP Address turns “Static IP to “DHCP Server”. Clicking“Apply”to enable “DHCP Server”.

Figure 15 DHCP server

Note：

The IP Address number that the “DHCP Server” generates shall be no less than the ones in clients

Time Server

Compliant with NTP, the ZMAX-8210 is capable of keep its time in complete accord with the internet time.

Opening“Basic Settings”guides you to the time setup.

Figure 16 Time Server

Time Server Setup：

Assign the proper IP address to the ZMAX-8210, ensuring this CPE to have access to the internet. For information on setting proper address, refer to IP Address.

From the“Time Server”，enter the correct time server. The following provides the time server

website.

a)time.windows.com

b)time-a.nist.gov

c)time.nist.gov

From the“Time Server”pop-menu, select your time zone.

Chapter 4 Advanced Configuration

- 17 -

Image 23

Contents Page Bold Indicates the function, important words, and so on CopyrightManagement TroubleshootingPage ZMAX-8210 Page Appearance IntroductionIntroduction Build Typical Infrastructure Key FeaturesWireless Point-to-Point Outdoors Typical Case Wireless Point-to-multipoint OutdoorsSystem Requirement Basic InstallationPackage Content Hardware InstallationGround Antenna Installation ZMAX-8210 Default Factory Settings Basic SettingsDefault Factory Settings How to Login Your ZMAX-8210 via WEB BrowserSafety Alert ZMAX-8210 General Information Device NameIP Address Bridge and Router ModeZMAX-8210 Wireless Parameters Wireless ParametersBuild the Infrastructure with WiMAX Base Station Create a Link between the ZMAX-8210 and WiMAX Base StationBasic Settings Router Mode Advanced ConfigurationAny IP Wireless Router ModeTime Server Dhcp ServerTypical Http Redirect Case Http RedirectHttp Redirect View Statistics Information ManagementView the ZMAX-8210 Basic Information Upgrade Firmware PasswordChapter Backup and RetrieveRetrieve and Backup Settings Reboot Restore Factory Default SettingsPutty Settings SSH Settings Management Why I fail to configure my ZMAX-8210？ TroubleshootingFrequently Asked Question FAQ Why my PC fails to access the internet?How I could know my PC has connected to the ZMAX-8210? Refer to Restore Factory Default SettingsZMAX-8210 Ping ZMAX-8210-I Spec Appendix a SpecificationsQAM 3/4 64QAM 3/4 ZMAX-8210-E Spec InterfaceModule ZMAX-8210-E Secure WEB Management Yes Interface Technical Terms Appendix B Technical TermsDevice and other devices Ascii Appendix C AsciiAppendix C Ascii Appendix D SSH Settings TrapServer Address Read Snmp Readcommunity Community Appendix D SSH Settings