Z-Com ZMAX-8210-I Basic Installation, System Requirement, Package Content, Hardware Installation

Page 11

Chapter 2 Basic Installation

System Requirement

Before installing the ZMAX-8210 Customer Premise Equipment, make sure your system meets these requirements

A PC coupled with 10/ 100Base-TX adapter

Configure the computer with a static IP address of 192.168.1.x (x cannot be 1) and 255.255.255.0 for the Subnet Mask

A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or Netscape Navigator 4.78 or above or Firefox

Package Content

If any missing or damaged, please contact your local seller.

Z-Com ZMAX-8210 Customer Premise Equipment

Power adapter and cord （48V，1A）

Accessories (For its full contents, please refer to accessory installation guide)

ZMAX-8210 Customer Premise Equipment Installation Guide

Hardware Installation

Follow the steps below to install your ZMAX-8210. (the different of hardware installation between ZMAX-8210-I and ZMAX-8210-E is antenna)

Make sure all components linked to the ZMAX-8210 are on hand.

A brace fixed on the back of the ZMAX-8210 is tabled on a perfect area like well-sized desk. Attach one end of water-proof cable to a water-proof connector. Alternatively, you can make a Category 5 UTP straight yourself.

Chapter 2 Introduction

- 5 -

Image 11

Contents Page Bold Indicates the function, important words, and so on CopyrightManagement TroubleshootingPage ZMAX-8210 Page Appearance IntroductionIntroduction Build Typical Infrastructure Key FeaturesWireless Point-to-Point Outdoors Typical Case Wireless Point-to-multipoint OutdoorsSystem Requirement Basic InstallationPackage Content Hardware InstallationGround Antenna Installation ZMAX-8210 Default Factory Settings Basic SettingsDefault Factory Settings How to Login Your ZMAX-8210 via WEB BrowserSafety Alert ZMAX-8210 General Information Device NameIP Address Bridge and Router ModeZMAX-8210 Wireless Parameters Wireless ParametersBuild the Infrastructure with WiMAX Base Station Create a Link between the ZMAX-8210 and WiMAX Base StationBasic Settings Router Mode Advanced ConfigurationAny IP Wireless Router ModeTime Server Dhcp ServerTypical Http Redirect Case Http RedirectHttp Redirect View Statistics Information ManagementView the ZMAX-8210 Basic Information Upgrade Firmware PasswordChapter Backup and RetrieveRetrieve and Backup Settings Reboot Restore Factory Default SettingsPutty Settings SSH Settings Management Why I fail to configure my ZMAX-8210？ TroubleshootingFrequently Asked Question FAQ Why my PC fails to access the internet?How I could know my PC has connected to the ZMAX-8210? Refer to Restore Factory Default SettingsZMAX-8210 Ping ZMAX-8210-I Spec Appendix a SpecificationsQAM 3/4 64QAM 3/4 ZMAX-8210-E Spec InterfaceModule ZMAX-8210-E Secure WEB Management Yes Interface Technical Terms Appendix B Technical TermsDevice and other devices Ascii Appendix C AsciiAppendix C Ascii Appendix D SSH Settings TrapServer Address Read Snmp Readcommunity Community Appendix D SSH Settings