Z-Com ZMAX-8210-E, ZMAX-8210-I user manual Backup and Retrieve, Chapter

Page 28

Click“Upload”to enable the file to be loaded to your ZMAX-8210.

Reboot your ZMAX-8210 and check whether the firmware has been upgraded in the Basic

Information.

Upgrade firmware via FTP

Enter the command ftp 192.168.1.1，admin and password.

After successful commanding, enter“put mercury.rmt”. If the upgrade is successful, the information will be shown as below.

C:\>ftp 192.168.1.1

Connected to 192.168.1.1.

220 (vsFTPd 1.1.3)

User (192.168.1.1:(none)): admin 331 Please specify the password. Password:

230 Using binary mode to transfer files. Login successful. Have fun. ftp> put mercury.rmt

200 PORT command successful. Consider using PASV.

150 Ok to send data.

226 File receive OK.

ftp: 发送 4075528 字节，用时 0.39Seconds 10423.35Kbytes/sec. ftp> quit

221Goodbye.

The ZMAX-8210 will be forced to reboot.

Warning：

When upgrading the firmware via FTP, the file name shall be mercury.rmt.

When upgrading, neither the ZMAX-8210, nor other devices connected to the infrastructure are allowed to be closed.

Backup and Retrieve

It is strongly recommended that you’d better back up some important files in case of something unexpected. If tragedy hits the ZMAX-8210, you have access to restore the important files by the backup. The ZMAX-8210 provides two ways to restore the backup.

Backup and Retrieve Files via Web ：

Chapter 5

- 22 -

Image 28

Contents Page Copyright Bold Indicates the function, important words, and so onTroubleshooting ManagementPage ZMAX-8210 Page Introduction IntroductionAppearance Key Features Build Typical InfrastructureWireless Point-to-Point Outdoors Wireless Point-to-multipoint Outdoors Typical CaseBasic Installation Package ContentHardware Installation System RequirementGround Antenna Installation Basic Settings Default Factory SettingsHow to Login Your ZMAX-8210 via WEB Browser ZMAX-8210 Default Factory SettingsSafety Alert Device Name ZMAX-8210 General InformationBridge and Router Mode IP AddressWireless Parameters ZMAX-8210 Wireless ParametersCreate a Link between the ZMAX-8210 and WiMAX Base Station Build the Infrastructure with WiMAX Base StationBasic Settings Advanced Configuration Router ModeWireless Router Mode Any IPDhcp Server Time ServerHttp Redirect Typical Http Redirect CaseHttp Redirect View the ZMAX-8210 Basic Information ManagementView Statistics Information Password Upgrade FirmwareBackup and Retrieve ChapterRetrieve and Backup Settings Restore Factory Default Settings RebootPutty Settings SSH Settings Management Troubleshooting Frequently Asked Question FAQWhy my PC fails to access the internet? Why I fail to configure my ZMAX-8210？Refer to Restore Factory Default Settings How I could know my PC has connected to the ZMAX-8210?ZMAX-8210 Ping Appendix a Specifications ZMAX-8210-I SpecQAM 3/4 64QAM 3/4 Interface ZMAX-8210-E SpecModule ZMAX-8210-E Secure WEB Management Yes Interface Appendix B Technical Terms Technical TermsDevice and other devices Appendix C Ascii AsciiAppendix C Ascii Appendix D SSH Settings TrapServer Address Read Snmp Readcommunity Community Appendix D SSH Settings