Z-Com ZMAX-8210-I, ZMAX-8210-E Create a Link between the ZMAX-8210 and WiMAX Base Station

Page 19

devices.

EncryptionThis field provides encryption options.

Note

When the communication is established, the encryption shall be completely identical between the ZMAX-8210 and the Base Station,

IR BitThis field identifies whether forward initial ranging data”。

Note

There shall be in complete accord in the parameters between IR Bit and Base Station.

Create a Link between the ZMAX-8210 and WiMAX Base Station

Acting as a customer premise equipment (CPE), the ZMAX-8210 aims at establish a tie with WiMAX Base Station to enable IP network to be connected to main arteries. We’ll elaborate how to build the infrastructure via the ZMAX-8210. The CPE has access to connect to the WiMAX Base Station via the Base Station ID. However, the Duplex Mode, Bandwidth and IR Bit shall conform to the requirements set when creating a link between the ZMAX-8210 and the Base Station.

Take the following steps to build your infrastructure.

Connect this CPE to PC via a cable. And assign 192.168.1.100 as your PC IP Address.

Figure 11 Build the Infrastructure with WiMAX Base Station

Enter the ZMAX-8210 web-based management. And set proper parameters in the “Base Station ID”, Duplex Mode,Bandwidth,EncryptionandIR Bitfields, respectively to establish a link between your CPE and the WiMAX Base Station.

Note

Chapter 3 Basic Settings

- 13 -

Image 19
Contents Page Bold Indicates the function, important words, and so on CopyrightManagement TroubleshootingPage ZMAX-8210 Page Introduction IntroductionAppearance Build Typical Infrastructure Key FeaturesWireless Point-to-Point Outdoors Typical Case Wireless Point-to-multipoint OutdoorsSystem Requirement Basic InstallationPackage Content Hardware InstallationGround Antenna Installation ZMAX-8210 Default Factory Settings Basic SettingsDefault Factory Settings How to Login Your ZMAX-8210 via WEB BrowserSafety Alert ZMAX-8210 General Information Device NameIP Address Bridge and Router ModeZMAX-8210 Wireless Parameters Wireless ParametersBuild the Infrastructure with WiMAX Base Station Create a Link between the ZMAX-8210 and WiMAX Base StationBasic Settings Router Mode Advanced ConfigurationAny IP Wireless Router ModeTime Server Dhcp ServerTypical Http Redirect Case Http RedirectHttp Redirect View the ZMAX-8210 Basic Information ManagementView Statistics Information Upgrade Firmware PasswordChapter Backup and RetrieveRetrieve and Backup Settings Reboot Restore Factory Default SettingsPutty Settings SSH Settings Management Why I fail to configure my ZMAX-8210? TroubleshootingFrequently Asked Question FAQ Why my PC fails to access the internet?How I could know my PC has connected to the ZMAX-8210? Refer to Restore Factory Default SettingsZMAX-8210 Ping ZMAX-8210-I Spec Appendix a SpecificationsQAM 3/4 64QAM 3/4 ZMAX-8210-E Spec InterfaceModule ZMAX-8210-E Secure WEB Management Yes Interface Technical Terms Appendix B Technical TermsDevice and other devices Ascii Appendix C AsciiAppendix C Ascii Appendix D SSH Settings TrapServer Address Read Snmp Readcommunity Community Appendix D SSH Settings