Vox AD50VT, AD30VT, AD10VT, AD15VT Line/Phone, External Speaker OUT jack, Send jack, Return jack

Page 13

This control lets you get that highly desirable, fat, warm sound of the Valvetronix power stage being driven hard (a common trait of all great valve power amps), at various levels. This will enable you to play comfortably in a small room or compro- mising your all-important tone.

LINE/PHONE

Use this jack if you’re plugging directly in to a mixer, recording device, or if you’re using headphones. The output from this jack is taken from immediately before the ValveReactor power amp, and the character of the guitar amp cabinet is applied to it.

NOTE: Connecting headphones to this jack will mute the internal speaker.

EXTERNAL SPEAKER OUT jack

You can connect a guitar speaker cabinet to this jack.

NOTE: Sound will not be output from the internal speaker if you use the exter- nal speaker jack.

NOTE: The AD15VT and AD30VT don’t have this jack.

Important: To ensure that your system works correctly, you must observe the follow- ing points.

a)Don’t use an external speaker whose impedance is other than 8 ohms.

b)Don’t connect a speaker whose rated input capacity is less than 50 watts (100 watts for the AD100VT). The speaker may be destroyed if you ignore this caution

— not recommended!

c)You must use a speaker cable to connect an external speaker. Don’t use a shielded cable like the one you use to connect a guitar to an amp.

d)You must turn off the power before connecting the cable. Connecting the cable while the power is turned on may damage your amp.

LOOP

These jacks let you connect an external effect loop.

SEND jack

Connect this to the input of your external effect unit.

RETURN jack

Connect this to the output of your external effect unit.

9

Image 13
Contents Page Important Safety Instructions Table of Contents Page Introduction Main FeaturesWelcome Aboard Power AMP and the Glory Signal PathValve Reactor Technology Quick Start SetupSwitching Between the Channels of a Program Checking OUT the Preset ProgramsCreating Your OWN Sounds Guitarist’s Guided Panel Tour VolumeInput Section AMP SectionTREBLE, MIDDLE, and Bass Effect SectionMaster EffectsPRESET/MANUAL/CHANNEL Section AC power Power SwitchPower Level Write buttonExternal Speaker OUT jack LINE/PHONESend jack Return jackChannel Select Mode Selecting a Channel Program Preset Mode Selecting a Preset ProgramAbout the three operating modes Switching Channels Manual ModeGetting to Manual Mode Creating Your OWN Program Creating and storing your own programWhen you’ve come up with a sound you like, store the program Adjusting the Noise ReductionStoring Your Program Checking the Settings of a Program Original ValuesTurn the power off Restoring the Factory SettingsSwitching the Channel Program Switch Using the VFS2 dual foot switchTurning Effect Bypass ON/OFF Switch Switching to Manual Mode SwitchAMP Models Amp models and effectsControlling Factors Tube Talk Power AMP AccuracyTurn IT UP Black Boutique CLAC15 UK ’70s Numetal UK ModernUS Higain Boutique ODEDIT1 EffectsEDIT2 EDIT3TAP CompFlanger Delay Amp isn’t powering up when the Power switch is on TroubleshootingYou can’t hear any effects Input/output jacks SpecificationsProgrammer’s Cheat Sheet Program Name EDIT2TAP+EDIT 1 /TAP