Vox AD10VT, AD30VT, AD50VT, AD15VT manual Delay

Page 30

DELAY

This is a model of one of the most respected analogue tape echo machines ever made. In the original the “echo” is produced by a playback head and the exact “delay time” is set by varying the motor speed. Many professionals prefer these “lo-fi” units because of the warm, dark echoes they produce.

TAP

“TIME”

Sets the delay time in a range of 1...1486 [ms].

EDIT1

“MIX”

Adjust the mix amount of the delayed sound.

EDIT2

“TIME”

This lets you use the knob to make fine adjustments

[TAP+EDIT 1]

 

to the parameter.

EDIT3

“FEEDBACK”

Adjusts the amount of feedback.

[BYPASS+EDIT 1]

 

 

HINT: In the CHORUS+DELAY combination effect, the FEEDBACK parameter is already set to the optimal value.

WARNING! If you crank up the FEEDBACK too much, an uncontrollable, cascading “run- away” of echoes will occur. So, use your ears and your common sense when setting this!

REVERB

A model of the most popular spring reverb system used in guitar amps.

TAP

“TIME”

Sets the reverb time in a range of 0.8...8 [seconds].

EDIT1

“MIX”

Adjusts the mix amount of the reverb sound.

EDIT2

“TIME”

This lets you use the knob to adjust the reverb time.

[TAP+EDIT 1]

 

 

EDIT3

“HI DAMP”

Adjusts the dampening of the high-frequency range.

[BYPASS+EDIT 1]

 

 

HINT: In combination effects, the TIME and HI DAMP parameters are already set to opti- mal values.

26

Image 30
Contents Page Important Safety Instructions Table of Contents Page Main Features IntroductionWelcome Aboard Signal Path Power AMP and the GloryValve Reactor Technology Setup Quick StartChecking OUT the Preset Programs Switching Between the Channels of a ProgramCreating Your OWN Sounds Input Section VolumeGuitarist’s Guided Panel Tour AMP SectionMaster Effect SectionTREBLE, MIDDLE, and Bass EffectsPRESET/MANUAL/CHANNEL Section Power Level Power SwitchAC power Write buttonSend jack LINE/PHONEExternal Speaker OUT jack Return jackPreset Mode Selecting a Preset Program Channel Select Mode Selecting a Channel ProgramAbout the three operating modes Manual Mode Switching ChannelsGetting to Manual Mode Creating and storing your own program Creating Your OWN ProgramAdjusting the Noise Reduction When you’ve come up with a sound you like, store the programChecking the Settings of a Program Original Values Storing Your ProgramRestoring the Factory Settings Turn the power offTurning Effect Bypass ON/OFF Switch Using the VFS2 dual foot switchSwitching the Channel Program Switch Switching to Manual Mode SwitchAmp models and effects AMP ModelsControlling Factors Power AMP Accuracy Tube TalkTurn IT UP Boutique CL BlackAC15 UK ’70s US Higain UK ModernNumetal Boutique ODEDIT2 EffectsEDIT1 EDIT3Comp TAPFlanger Delay Troubleshooting Amp isn’t powering up when the Power switch is onYou can’t hear any effects Specifications Input/output jacksProgrammer’s Cheat Sheet Program Name EDIT2TAP+EDIT 1 /TAP