Vox AD30VT, AD50VT, AD10VT, AD15VT Creating and storing your own program, Creating Your OWN Program

Page 16

Creating and storing your own program

here are two ways you can do this; by tweaking an existing preset program that’s Tclose to what you have in mind, or by starting from scratch.

CREATING YOUR OWN PROGRAM

Let’s start from scratch.

1.Choose any program in Preset or Channel Select mode, or select Manual mode.

HINT: Since we’re starting from scratch it doesn’t matter what program you choose.

2.Use the BYPASS button to bypass the effect. (The BYPASS LED is lit.) If you want to use an effect, you can add it at the end of this process.

3.Use the AMP selector to select the amp you want to use.

HINT: For details on the amp types, refer to “Amp models and effects” (page 17).

4.Adjust the top panel GAIN, VOLUME, TREBLE, MIDDLE, and BASS knobs as desired.

5.Hold down the TAP button and turn the EDIT 1 knob to adjust the noise reduction. This setting is also saved as part of your program. For details, refer to “Adjusting the noise reduction” (page 13)

HINT: Adjust the noise reduction so that you don’t hear noise when you’re not playing your guitar.

6.If you want to use an effect, press the BYPASS switch once again to turn bypass off (the BYPASS LED goes dark).

7.Select an effect, and make adjustments. For example if you want to add delay, turn the EFFECT selector to “DELAY.” If the selector is already set to “DELAY,” you’ll have to turn it to a different effect and then back to “DELAY.” Use the TAP button or EDIT 1 knob to adjust the delay time and delay level (the amount of delayed sound).

DELAY TIME:

Press the TAP button twice (at the desired interval), or hold

 

down the TAP button and turn EDIT 1.

DELAY LEVEL:

Turn EDIT 1 (without pressing any button).

DELAY FEEDBACK:

Turn EDIT 1 while holding down the BYPASS button.

12

Image 16
Contents Page Important Safety Instructions Table of Contents Page Introduction Main FeaturesWelcome Aboard Power AMP and the Glory Signal PathValve Reactor Technology Setup Quick StartSwitching Between the Channels of a Program Checking OUT the Preset ProgramsCreating Your OWN Sounds Volume Guitarist’s Guided Panel TourInput Section AMP SectionEffect Section TREBLE, MIDDLE, and BassMaster EffectsPRESET/MANUAL/CHANNEL Section Power Switch AC powerPower Level Write buttonLINE/PHONE External Speaker OUT jackSend jack Return jackChannel Select Mode Selecting a Channel Program Preset Mode Selecting a Preset ProgramAbout the three operating modes Switching Channels Manual ModeGetting to Manual Mode Creating and storing your own program Creating Your OWN ProgramAdjusting the Noise Reduction When you’ve come up with a sound you like, store the programChecking the Settings of a Program Original Values Storing Your ProgramRestoring the Factory Settings Turn the power offUsing the VFS2 dual foot switch Switching the Channel Program SwitchTurning Effect Bypass ON/OFF Switch Switching to Manual Mode SwitchAMP Models Amp models and effectsControlling Factors Tube Talk Power AMP AccuracyTurn IT UP Boutique CL BlackAC15 UK ’70s UK Modern NumetalUS Higain Boutique ODEffects EDIT1EDIT2 EDIT3Comp TAPFlanger Delay Troubleshooting Amp isn’t powering up when the Power switch is onYou can’t hear any effects Specifications Input/output jacksProgrammer’s Cheat Sheet Program Name EDIT2TAP+EDIT 1 /TAP