Panasonic CF-74GCDADBM service manual Removing the Dimm Memory Card

Page 24

9.1.4.Removing the DIMM Memory Card

<N1>

<N1>

DIMM Cover

 

Hook

Hook

DIMM Memory Card

1.Remove the two Screws <N1>, and remove the DIMM Cover.

2.Open the right and left Hooks of the DIMM Memory Card outward, and remove the DIMM Memory Card.

Screws <N1>: XSB2+3FNL

9.1.5.Removing the Keyboard

Hooks

1.Release the seven Hooks fixing the rear side of the Cen- ter Cover.

Hooks

Center Cover

Hooks

<N9>

KBD Angle L

<N9>

Keyboard

KBD Angle R

2.Lift the upper part of the Center Cover and draw it back- ward, release the six Hooks fixing the front side of the Center Cover, and then remove the Center Cover.

3.Remove the four Screws <N9> and the KBD Angle L and R.

4.Lift the upper part of the Keyboard and draw it backward, and then turn the Keyboard over forward.

KBD WP Sheet

Connectors

Keyboard

Connector

 

(CN25)

KBD FPC

5.Remove the KBD WP Sheet.

6.Disconnect the two KBD Cables from the two Connectors (KBD FPC).

7.Remove the Keyboard.

8.Disconnect the Cable from the Connector (CN25).

9.Remove the KBD FPC,

Screws <N9>: DFHE5025XA

9.1.6. Removing the Speaker and the LED PCB

 

Sheet

CN1002

<N9>

 

Tape

CN1003

LED PCB

Speaker

 

Holder

Tape

Speaker L

 

 

Speaker

 

Holder

 

Speaker R

1.Remove the two Speaker Holders.

2.Remove the two tapes, and disconnect the two Speaker Cables from the two Connectors (CN1002, CN1003)

3.Remove the Speaker L and R.

4.Remove the Sheet.

5.Remove the two Screws <N9>, and Remove the LED PCB.

9-2

Image 24
Contents Model No. CF-74GCDADBM Page Laser Safety Information Page Page Contents Specifications Wireless LAN Only for model with wireless LAN Data transfer rate of DVD per 1X speed is 1,350 KB/s Names and Functions of Parts Right side Block Diagram Page Troubleshooting Power-On Self Test Boot Check Stuck key 02D0 System cache error Cache disabled Self Diagnosis Test Operation of PC-Diagnostic Utility Selection of tested device To skip Bios password Wiring Connection Diagram Battery Pack PreparationRemoving the HDD HDD UnitRemoving the Dimm Memory Card Removing the Handle Assy Removing the Bottom CaseRemoving the Wireless Module and MDC Module Removing the PC Card Ejector Lithium BatteryRemoving the Main PCB PCB Removing the USB PCB Removing the Display unitRemoving the LCD Front Cabinet Removing the LCD and the InverterRemoving the Touch PAD and PAD PCB Removing the Finger PCBPreparation Reassembly Instructions Arranging the W-LAN L and R Cable Attaching the LCD Damper C and LCD Damper DArranging the LCD/TS Cable Attaching the ClothArranging the TP Power Cable and Attaching the TP/LCD Sheet Setting the Inverter and Arranging the Inverter CableLCD Unit Setting the LCD Front Cabinet Setting the Display unitFixing of the LCD Front Cabinet Setting the USB PCB Arranging the USB CableSetting the BT PCB Setting the SD PCB, Heat Sink FAN MotorApplying Grease on the Heat Sink Setting the DC-IN PCB and I/O PCB Arranging the DC-IN CableSetting the PC Card Ejector and Lithium Battery Arranging the Lithium BatteryArranging the FAN Cable Setting the Wireless Module and MDC Module Arranging the Modem CableSetting the Bottom Case Setting the Handle AssySetting the Speaker and the LED PCB Soldering the Speaker Cable and Setting the Speaker RubberSetting the Keyboard Computer, and set the Keyboard to the computerSetting the Dimm Memory Card and Dimm Cover Setting the HDDLatch HDD Unit Battery Pack DVD-ROM Drive Unit Exploded View Screw tightening torque Screw tightening torque CF-74GCDADBM Replacement Parts List Accessories DFHR6214ZB Sleeve B DFBH3045YB Hinge L Description EEFCX0G151R Thermistor Serial Eeprom B1GBCFNN0042 Transistor DEARA8AJ104M Resistor Array ERJ2RKF1502X RESISTOR, 1/16W, 15KΩ DC-IN PCB SD PCB