Panasonic CF-74GCDADBM service manual Setting the USB PCB, Arranging the USB Cable

Page 36

9.2.6.Setting the USB PCB

1.

Fix the USB PCB to the computer using the two

<N9>

 

Screws<N9>.

2.

Connect the USB Cable to the Connector (CN1701).

CN1701

 

Screws <N9>: DFHE5025XA

USB PCB

Arranging the USB Cable

Safety Working

MP Slide Sheet

Attach the MP Slid Sheet to prevent the Cable from coming off.

S2

Fitting edge

Connect

the Connector.

Pass it through the notch.

USB Cable

 

Tape

Ensure the Cable does not

 

come out of the board edge

Pass it through

so that the Cable does not

touch the MP Drive.

the notch.

Avoid runnning over the boss.

MP Slide Sheet

A

Pass the Cable through

the notch and lead it downward.

Fit the surplus length of the Cable into this side.

Fit the Cable between the pins.

Pass it through the rib.

Ensure the "A" end does not come on the level.

9-14

Image 36
Contents Model No. CF-74GCDADBM Page Laser Safety Information Page Page Contents Specifications Wireless LAN Only for model with wireless LAN Data transfer rate of DVD per 1X speed is 1,350 KB/s Names and Functions of Parts Right side Block Diagram Page Troubleshooting Power-On Self Test Boot Check Stuck key 02D0 System cache error Cache disabled Self Diagnosis Test Operation of PC-Diagnostic Utility Selection of tested device To skip Bios password Wiring Connection Diagram Battery Pack PreparationRemoving the HDD HDD UnitRemoving the Dimm Memory Card Removing the Handle Assy Removing the Bottom CaseRemoving the Wireless Module and MDC Module Removing the PC Card Ejector Lithium BatteryRemoving the Main PCB PCB Removing the USB PCB Removing the Display unitRemoving the LCD Front Cabinet Removing the LCD and the InverterRemoving the Touch PAD and PAD PCB Removing the Finger PCBPreparation Reassembly Instructions Arranging the W-LAN L and R Cable Attaching the LCD Damper C and LCD Damper DArranging the LCD/TS Cable Attaching the ClothArranging the TP Power Cable and Attaching the TP/LCD Sheet Setting the Inverter and Arranging the Inverter CableLCD Unit Setting the LCD Front Cabinet Setting the Display unitFixing of the LCD Front Cabinet Setting the USB PCB Arranging the USB CableSetting the BT PCB Setting the SD PCB, Heat Sink FAN MotorApplying Grease on the Heat Sink Setting the DC-IN PCB and I/O PCB Arranging the DC-IN CableSetting the PC Card Ejector and Lithium Battery Arranging the Lithium BatteryArranging the FAN Cable Setting the Wireless Module and MDC Module Arranging the Modem CableSetting the Bottom Case Setting the Handle AssySetting the Speaker and the LED PCB Soldering the Speaker Cable and Setting the Speaker RubberSetting the Keyboard Computer, and set the Keyboard to the computerSetting the Dimm Memory Card and Dimm Cover Setting the HDDLatch HDD Unit Battery Pack DVD-ROM Drive Unit Exploded View Screw tightening torque Screw tightening torque CF-74GCDADBM Replacement Parts List Accessories DFHR6214ZB Sleeve B DFBH3045YB Hinge L Description EEFCX0G151R Thermistor Serial Eeprom B1GBCFNN0042 Transistor DEARA8AJ104M Resistor Array ERJ2RKF1502X RESISTOR, 1/16W, 15KΩ DC-IN PCB SD PCB