Outlaw Audio 1070 Using Headphones, Creating an AM or FM station-memory preset manually

Creating an AM or FM station-memory preset manually:

1.Tune the station you want to enter into memory following the directions shown above.

2.Press the Memory button on the remote.

You will see “Memory” immediately above the broadcast frequency in the front panel and on-screen displays.

If any station presets have already been entered, you’ll see a number immediately after “Memory.” The first digit of that number will flash.

3.Within 5 seconds, enter a two-digit memory number (from 01 to 30) using the remote’s numeric keypad.

4.Wait a few seconds as the present number is entered into the Model 1070’s memory.

The first digit of the preset number will blink. This is your indication that the memory is being loaded.

5.The word MEMORY changes to PRESET and the first digit of the number will stop flashing.

This is your indication that the preset number has been memorized.

Note: If the memory number you have chosen was previously used for another station, that memory will be overwritten with the new sta- tion preset number.

AM station presets must be entered manually, they cannot be entered using the automated process described below.

To create FM station-memory presets automatically:

nPress and hold the remote’s Memory button for three seconds, then release it.

The tuner will automatically scan the FM band for all active stations, and create memory presets for the first 30 stations tuned with a signal that has acceptable strength for good reception.

To select a preset station:

nFrom the remote, press the Preset Up or Preset Down buttons to scan through the list of preset stations.

OR

1.From the front panel, press the PRESET button.

2.Press the or buttons to scan through the list of preset stations.

Using Headphones

The Model 1070’s front headphone jack allows you to listen in private without disturbing others nearby. You may enjoy headphone listening in either pure stereo or thanks to the Model 1070’s Dolby Headphone processing, you can enjoy a realistic surround-sound effect even when using headphones.

The Model 1070 has a 1/4-inch headphone jack, which accommodates the 1/4-inch plugs found on most quality headphones. If you want to use portable- style headphones such as those included with portable CD or MP3 players, you will need a stereo 1/8-inch to 1/4-inch adapter, which is readily available at RadioShack and other electronics stores.

Owner’s Manual

Model 1070 Operation

To use the headphones:

1.Plug a set of headphones in to the front panel using the headphone jack.

The signal to the main speaker outputs will automatically mute when the headphones are in use.

2.Use the Headphone Level Control to the right of the headphone jack to set the sound level for the headphones

The main system front panel or remote volume controls do not have any influence on the headphone level setting.

CAUTION: We recommend that you turn the headphone level control all the way down before using headphones for the first time, and then slowly increasing the level by turning the knob to the right. This avoids the chance that you might damage your hearing by encountering a headphone level that is too high. Always use caution and good sense when setting the headphone level, as high levels may cause hearing damage. Listening to headphones for prolonged periods at high vol- ume levels can permanently damage your hearing

The headphones may be used in either the Stereo or Dolby Headphone mode. To change the setting, go to the Surround Configuration Menu, following the instructions shown on page 33.

Model 1070 7.1 Channel Surround Sound Receiver

41