Panasonic PT-ST10EA manual Wired LAN settings, Menu’s Operating guidance, Default network settings

Page 6

Network setting of the projector (cont.)

NETWORK

Wired LAN settings

You can make detailed wired LAN settings.

11 Select [WIRED LAN] in the NETWORK menu and press the [ENTER] button.

WIRED DETAILED SETUP

CANCEL

SELECT

DHCP	OFF
IP ADDRESS
IP ADDRESS	192.168.	10.100
SUBNETMASK	255.255.255.		0
DEFAULT GATEWAY
DEFAULT GATEWAY	192.168.	10.	1

OK CANCEL

	DHCP
	ON:	If a DHCP server exists in the network to which the projector is connected, the IP address will automatically be
		acquired.
	OFF:	If a DHCP server does not exist in the network to which the projector is connected, additionally set [IP
		ADDRESS ], [SUBNETMASK ] and [DEFAULT GATEWAY ].
	“Glossary” (See page 18)
22	Select each item with the [▲▼] buttons and change the settings following the
22	menu’s Operating guidance.
33	Select [OK] with the [▲▼] buttons and press the [ENTER] button.

Default network settings

The following settings are set before the projector leaves the factory.

DHCP	OFF
IP ADDRESS	192.168.10.100
SUBNETMASK	255.255.255.0
DEFAULT GATEWAY	192.168.10.1

6

Image 6

Contents PT-ST10EA PT-ST10U Contents WEB control See Request Regarding SecurityWhat you can do PJLink SeeNecessary environment for computers to be connected Connecting with Wired LANCheck your computer Turn on the computerSelect Network with the buttons Network setting of the projectorPress the Menu button on the projector Press the Enter buttonMenu’s Operating guidance Wired LAN settingsDefault network settings Select OK with the buttons and press the Enter buttonSelect Network Control in the Network menu Select on or OFF with the buttonsNetwork Dhcp MAC AddressUsing WebBrowser Before using the WEB control„„Proxy server settings WebBrowser starts up and the authentication window appears Level and check the Enable checkbox under Active scriptingEnter the User name and the Password Click OK Open Internet Properties window„ If Failed appears Monitor information window„ Network status DescriptionDetailed set up window Projector control windowComplete the detailed settings and click Next „„Adjust clockClick Submit „„E-mail set up „„Ping test„„If Normal is selected under Mail Contents „„If Simple is selected under Mail Contents„„Authentication set up Change password windowSwitching Languages „„Command port set upUsing PJLink protocol „„PJLink security authenticationCommand Control details Glossary Trademarksヱㄏㄔㄐㄏㄊチヤㄐㄓㄑㄐㄓㄕㄊㄐㄏ