Panasonic PT-ST10E Monitor information window, „ Network status, „ If Failed appears, Description

Page 11

Using WebBrowser (cont.)

Monitor information window

This page indicates the projector status.

To access this page from other pages, click [Status] in the main menu (at the left of the window).

„

„

„ Projector status

„ Network status

On this window, click the [Projector status] tab.

On this window, click the [Network status] tab.

The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View] → [Refresh].

If [SELF TEST Error (Detail)] appears on the Monitor information window, click it to view the error details.

„

 

„ If [FAILED] appears

 

Item

Description

MAIN CPU BUS

There is a problem with a microcontroller circuit. Contact your dealer.

FAN

There is a problem with the fan or fan drive circuit. Contact your dealer.

INPUT AIR TEMPERATURE

Input air temperature is high. The projector is likely being used in a high temperature

 

environment such as near heating equipment.

OUTPUT AIR TEMPERATURE

Temperature surrounding the lamp is high. The exhaust vent is likely blocked.

LAMP REMAIN TIME

The lamp has been used for longer than its rated useful life, and it is time to replace it.

LAMP STATUS

The lamp could not be lit.

 

Allow the bulb of the light source to cool, and then turn on the projector.

INPUT AIR TEMP.SENSOR

There is a problem with the air intake temperature sensor. Contact your dealer.

OUTPUT AIR TEMP.SENSOR

There is a problem with the exhaust temperature sensor. Contact your dealer.

BATTERY

The battery must be replaced. Contact your dealer.

AIR FILTER

The remaining filter gets low.

 

For further detail, see the Basic Manual.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents PT-ST10EA PT-ST10U Contents PJLink See Request Regarding SecurityWhat you can do WEB control SeeTurn on the computer Connecting with Wired LANCheck your computer Necessary environment for computers to be connectedPress the Enter button Network setting of the projectorPress the Menu button on the projector Select Network with the buttonsSelect OK with the buttons and press the Enter button Wired LAN settingsDefault network settings Menu’s Operating guidanceSelect on or OFF with the buttons Select Network Control in the Network menuMAC Address Network Dhcp„„Proxy server settings Using WebBrowserBefore using the WEB control Open Internet Properties window Level and check the Enable checkbox under Active scriptingEnter the User name and the Password Click OK WebBrowser starts up and the authentication window appearsDescription Monitor information window„ Network status „ If Failed appearsProjector control window Detailed set up windowClick Submit Complete the detailed settings and click Next„„Adjust clock „„Ping test „„E-mail set up„„If Simple is selected under Mail Contents „„If Normal is selected under Mail Contents„„Command port set up Change password windowSwitching Languages „„Authentication set upCommand Control details Using PJLink protocol„„PJLink security authentication Trademarks Glossaryヱㄏㄔㄐㄏㄊチヤㄐㄓㄑㄐㄓㄕㄊㄐㄏ
Top Page Image Contents