Panasonic PT-L595U manual Adjusting the lens, Adjustment procedure for direct adjustment

Page 17

Adjusting the lens

The projector is equipped with electronic zoom and electronic focusing mechanisms, so that you can carry out adjustments simply by pressing the ZOOM (+/-) buttons and the FOCUS (+/-) buttons on the top of the projector, or by following the on-screen adjustment display. Alternatively, you can adjust the focus by turning the lens directly.

NOTE:

If these buttons are pressed while the on-screen display for some other function is on the screen, the buttons pressed will operate but the on-screen display will not switch to the ZOOM or FOCUS adjustment screen. Thus there may be cases where the operation and the display do not match.

Adjustment procedure <for direct adjustment>

1. Press the ZOOM (+/-) buttons on the operation panel on the top of the projector to adjust the size of the picture.

If the “+” button is pressed, the picture becomes larger, and if the “-” button is pressed, the picture becomes smaller.

2. Press the FOCUS (+/-) buttons on the operation panel on the top of the projector to adjust the focus of the picture.

Adjust so that the image projected onto the screen is at the optimum focus.

NOTE:

If approximately five seconds pass without any buttons being pressed, the adjustment screen will be cleared.

Adjustment procedure <adjusting using the on-screen adjustment display>

1.Press the MENU button to display the MENU screen.

2.Press the “ ” and “ ” buttons to select “ZOOM”.

3.Press the “<” and “>” buttons to display the ZOOM adjustment screen.

4.Press the “<” and “>” buttons to adjust the picture size.

If the “+” button is pressed, the picture will become larger, and if the “-” button is pressed, the picture will become smaller.

5.Press the MENU button, or wait for approximately five seconds without pressing any button. The display will then return to the MENU screen.

6.Press the “ ” and “ ” buttons to select “FOCUS”.

7.Press the “<” and “>” buttons to display the FOCUS adjustment screen.

8.Press the “<” and “>” buttons to adjust the picture focus.

Adjust so that the image projected onto the screen is at the optimum focus.

NOTE:

If approximately five seconds pass without any buttons being pressed, the display will return to the MENU screen. The projector is equipped with a lens retracting function which will cause the lens to be retracted automatically when the power is turned off. However, the lens will not then return to the previously adjusted position even if the power is turned back on again. If you do not wish this function to operate, turn the function setting off while referring to “Using the lens retracting function” on page 31.

16

Page 16 Page 18
Image 17
Page 16 Page 18
Contents LCD Projector Dear Panasonic Customer ContentsFeatures Important Safety Notice Setting-up Precautions with regard to safetyWhen using the projector If problems occur during useTake particular care when replacing the lamp unit Cleaning and maintenanceDo not place any heavy objects on top of the projector Do not look into the lens while the projector is being usedAbout condensation Precautions on handlingSide view Location and function of each partFront view Top and front RGB 2 RGB IN/AUDIO Back, bottom and right viewSide terminal board Before using the remote control unit If facing the remote control unit toward the screen Operating range of the remote control unitTurning on the power Turning the power on and offTurning off the power Power button Main Power switchScreen requirements Screen characteristics referenceStandard setting-up dimensions Standard setting-up positionsProjection size Projection distance L Minimum MaximumAdjusting the position of the projected picture Retracting the adjustable legs Setting the projector up horizontallyAdjustment procedure Adjuster button Adjustable legsAdjustment procedure for direct adjustment Adjusting the lensSetting procedure Setting-up positions and changing the projection methodFront mounting Rear mountingChanging the input source Basic operationSignal data No. of dots Switching the signal mode during RGB signal inputAuto VesaAuto System format selection for S-VIDEO Video input signalsNtsc SecamAdjusting the volume Adjusting the picture to the desired setting BAL R BAL G BAL B Adjusting the white balanceAdjustment procedure for volume adjustment Adjusting the sound to the desired settingWhen adjusting the horizontal position H-POSI Adjusting the picture positionWhen adjusting the vertical position V-POSI Adjustment procedure for horizontal position adjustmentLeft-side blanking correction for the H-BLK-L Adjusting the blankingTop blanking correction for the V-BLK-T Bottom blanking correction for the V-BLK-BWhen decreasing the horizontal amplitude Adjusting the horizontal amplitudeWhen increasing the horizontal amplitude Numeric adjustment Level display Adjustment procedure Disabling the Power button of the remote control unit Using other useful functionsChanging the on-screen display language to another language Using the power save function Setting procedure Example of connection to audio-visual equipment System configuration exampleAudio system Laser disc player VCRSUB Example of connection to a computerSUB HD Accessory mouse cable Display mode name/No. of dots S1 S2 S3 S4 S5 S6About the Macintosh adapter OperationPin layout and signal names for Serial connector Using the serial connectorCommunication settings Basic formatCable specifications Control commandsLamp indicator Temp indicator IndicatorsProblem Possible cause RemedyIndent Air filter clamp Air filter cover Cleaning the air filterInstall the air filter cover Clean the air filter and the air filter clampsReplacing the lamp unit Lamp unit replacement periodFixing screw for the lamp unit Replacement procedureLamp unit cover Fixing screw for the lamp unit cover Page Possible cause Before asking for service, check the following pointsRGB HD/SYNC RGB OUT Audio Video Audio in L-R SpecificationsCeiling Mount Bracket ET-PK592 Trademark AcknowledgementsFCC Dimensions Western Zone Eastern ZoneCentral Zone
Top Page Image Contents