Getting Started
Other settings
Smart function key ( 
key)
The Smart function key ( 
key) is located
on the bottom of the handset and informs you with its flashing to allow you to activate the following features by simply pressing this key.
nWhen the 
indicator flashes rapidly, you can:
–Answer the call (outside call, intercom). (page 21, 24)
–Stop paging.
–Stop the alarm sound. (page 40)
nWhen the 
indicator flashes slowly in standby mode, you can:
–Listen to new messages. (page 52)
–Listen to new voice mail messages. (page 59)
–View the caller list when there are missed calls. (page 45)
To activate these features, their Smart function key must be “On”. (page 15)
Using the Smart function key ( 
key)
When the 
indicator flashes rapidly/slowly, press M 
N.
RThe above features can be activated depending the situation.
RIf you answer a call using the Smart function key, the speakerphone is activated.
REven if the handset is placed on the base unit or charger, the feature can be activated. You can talk or listen to new messages without lifting up the handset. If you want to perform further operations, lift up the handset.
RWhen the unit has new messages, new voice mail messages, and missed calls, the unit can be operated to play the new messages first, play the new voice mail messages next, and then show the missed calls.
Setting the Smart function key
The Smart function key for the following features must be “On”.
–“New message” (Default: On)
–“New VM” (Default: On)
–“Missed call” (Default: Off)
The settings can be set for each handset.
1MMENUN (right soft key) #278
2MbN: Select the desired setting and press
MSELECTN.
R “ 
” is displayed next to the selected features.
R To cancel a selected feature, press MSELECTN again. “ 
” disappears.
3MSAVEN a MOFFN
Note:
RIf the 
indicator flashes when the handset is not placed on the base unit or charger, battery consumption is faster than usual.
Dialing mode
If you cannot make calls, change this setting according to your telephone line service. The default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1MMENUN (right soft key) #120
2 MbN: Select the desired setting.
3 MSAVEN a MOFFN
Screen saver mode
The backlight goes dark when on a call or turns off completely after 1 minute of inactivity if the handset is not on the base unit or charger.
Activate the handset display again by:
–pressing M
N when on a call.
–pressing MOFFN at all other times.
For assistance, please visit http://www.panasonic.com/help | 15 |