Panasonic AWHE50HN manual WwManually adjusting the shutter speed

The shutter speed can be set using two methods. One is a method that specifies the time (where a time such as 1/250 sec. is designated), and the other is a method that specifies the frequency (where synchro scan, 60.24 Hz, etc. is designated).

When shooting a TV screen or PC monitor screen, the horizontal noise generated when the screen is shot can be minimized by adjusting the frequency to the screen frequency using synchro scan.

When performing the operations using the wireless remote control

Perform the adjustments on the Camera menu. For further details, refer to the [Shutter Mode] and [Step/Synchro] items on page 40.

When performing the operations using the controller

The procedure is the same as for “When performing the operations using the wireless remote control” in “Basic operations” (pages 30 to 37).

When the AW‑RP555 is connected:

qqHow to set the shutter speed using the AW‑RP555

1With the [MEMORY] button still held down, press the [SHUTTER] button.

The [PRESET] [1] to [5] and [6] to [10] buttons blink alternately.

2Press one of the [1] to [8] buttons or the

[10] [PRESET] button — whichever button corresponds to the shutter speed which is to be set.

Any of the shutter speeds in the table below can be set.

ppAny change in the shutter speed is reflected the next

time the [SHUTTER] button is pressed and its lamp is turned on.

ppWhen OFF is selected, the shutter will not operate even when the [SHUTTER] button is pressed.

ppSelect the synchro scan setting on the menu.

ppThe shutter speed setting performed here is stored in the memory even when the power of the AW‑RP555 is turned off.

For further details, refer to the Operating Instructions of the AW‑RP555.