Connecting Windows 2000 Systems, Workflow | Fujitsu ST4000 specification

CONNECTING WINDOWS 2000 SYSTEMS

This chapter describes how to set the wireless LAN connection for computers running Windows 2000.

P O I N T

If you purchased a Stylistic ST4000 Series Tablet PC with the optional integrated wireless LAN device, the device and drivers have already been installed. This procedure outlines the steps for setting the device parameters.

Updated drivers and/or utilities may become available after this manual is printed; see any addenda or fliers that may be included in the system packaging.

Workflow

The proper setup of the wireless LAN requires several steps which must be performed in the proper order. Following is a general outline of the steps that must be performed. Each step is detailed later in this procedure.

1.Setting parameters

■Setting the profile

■Setting the encryption

2.Network settings

■Setting the protocol and checking the network

■Setting file and printer sharing

■Checking the connection

Setting Parameters

1.Click [Start]-> [Settings] -> [Control Panel].

2.Double-click the [PRISM Settings] icon. The [PRISM Wireless Settings] appears.

3.Set the profile as specified in Table 1. Ask your network administrators to check the setting.

4.When you finish your entry, click [Apply].

Item	Description

Profile	Enter the system file name in which the
	parameter information is to be saved.

Mode	Ad Hoc Network: Click the down arrow
	and select “802.11 AdHoc”.
	Infrastructure Network: Click the down
	arrow and select “Infrastructure”.

SSID	Enter the network name to which you
	want to connect

Transmit	Obtain the information from your
Rate	network administrator. If you do not have
	a network administrator, select “Fully
	Automatic”.

W i r e l e s s L A N U s e r ’ s G u i d e

Item	Description

Power	Not supported.
Save
Enabled

AdHoc	AdHoc Network: Select the same
Channel	channel, 1-11, for all connected
	computers. If there is more than one
	wireless LAN nearby (such as on the same
	floor), we recommend that the channels
	for each LAN be 5 numbers apart (e.g., if
	there are two other LANs nearby, the
	channels used should be 1, 6, and 11).
	Infrastructure Network: Not an option.

	Table 1: Profile Parameters

5.Click the [Encryption] tab.

6.Set the encryption items in accordance with Table 2.

■AdHoc Network: Specify the same value for all the computers for which the encryption key is used for connection.

■Infrastructure Network: Specify the identical encryp- tion keys to the encryption keys set for the access point. For instructions on how to check the encryp- tion keys set for the access point, refer to the access point manual.

P O I N T

Make sure that you specify the encryption keys. If you do not specify the keys, any computer with a wireless LAN card can be connected. This presents a risk that your data may be stolen or destroyed.

Item		Description

Encryption	Click the down arrow and select an
(WEP)	encryption option.
	■	Disable: Disables the encryption. In
		this case, “Create keys with Pass-
		phrase” and subsequent items are
		greyed out, and you cannot enter
		anything.
	■	40 bit*: The encryption is set.
		Select either “Create keys with
		Passphrase”, “Create keys manu-
		ally”, or “ASCII Input”, and enter
		the encryption keys.
	■	104 bit*: The encryption is set.
		Select either “Create keys with
		Passphrase”, “Create keys manu-
		ally”, or “ASCII Input”, and enter
		the encryption keys.