Fujitsu ST4000 warranty Troubleshooting Table

Page 65

W i r e l e s s L A N U s e r ’ s G u i d e

TROUBLESHOOTING

This section contains troubleshooting information, including causes and actions, for problems you may find while using this device.

Troubleshooting Table

	Problem	Possible Cause		Possible Solution


	An exclamation mark	A failure to	Restart the computer.
	(!) or cross (x) is	recognize the device.
	attached to [Intersil
	attached to [Intersil	A failure in installing	Restart the computer.
	PRISM Wireless LAN	A failure in installing	Restart the computer.
	PCI Card].	the driver.

	Other computers are	The network has not	Check the setting for the protocol, workgroup, and sharing.
	not displayed when	been set up correctly.	To check this, you need a different procedure, depending upon the
	the [Network
	the [Network		operating system that you use. Refer to the appropriate section of
	Computer] icon is
	Computer] icon is		this chapter.
	double-clicked.		this chapter.
	double-clicked.
		It takes time before	Perform the following steps to search for the computer.
		the network is	■	Click [Start] -> [Search] -> [Other Computers].
		searched and the	■	Click [Start] -> [Search] -> [Other Computers].
		searched and the	■	Enter the computer name that you are connecting to in [Name],
		computer connected	■
		computer connected		and click [Search].
		is displayed.		and click [Search].
		is displayed.	■	Double-click the icon of the computer that has been searched.

		A failure in installing	Make sure that the driver is correctly installed.
		the driver.

		The TCP/IP protocol	Make sure that the TCP/IP protocol is installed. To check this, you
		is not installed, or,	need a different procedure, depending on the operating system that
		the IP address is not	you use. Refer to the appropriate section of this manual.
		set correctly.

		The TCP/IP protocol	If the TCP/IP protocol is installed, do the following to check the IP
		is not installed, or,	address:
		the IP address is not	1.	Windows 2000:
		set correctly.	1.	Windows 2000:
		set correctly.		Click [Start] -> [Programs] -> [Accessories] -> [Command
				Click [Start] -> [Programs] -> [Accessories] -> [Command
				Prompt].
			Windows XP:
				Click [Start] -> [All Programs] -> [Accessories] ->
				[Command Prompt].
			2. Enter “IPCONFIG” command, and press [Enter].
				(If your hard disk is C drive, enter
				C:\>ipconfig)
			Check that the IP address is correctly displayed under the IP Address.
			Example:
			IP address: 10.0.1.3
			Subnet Mask: 255.255.255.0
			Default Gateway: 10.0.1.1

		No communication	Shorten the distance between computers or remove visible obstacles
		due to poor radio	between them, and retry the connection.
		signal.

55

Image 65

Contents Complies with Part 15 of the FCC Rules Fujitsu PC CorporationPage Table of Contents Appendix Preface Page Fujitsu Contact Information Warranty InformationAbout this Guide Page Getting Started with Your Tablet PC Page IN-BOX Items for the Stylistic ST4000 Series Tablet PC Getting Started with Your Stylistic Tablet PCOptional Accessories Front Features Stylistic Tablet PC FeaturesThermal Suede Memory module cover Removable cover over the memory modulesTop Features Left-Side Features Right-Side Features Icon Mode/State LED State Remarks Status DisplayHDD AccessApplication Buttons Tablet Button SettingsTablet Icon DescriptionApplication Buttons Primary and Secondary Functions Navigation Buttons Tertiary Functions of Application and Navigation Buttons Connector Connectors and Peripheral InterfacesPurpose PeripheralNetwork LAN Connector Tablet PC Purpose PeripheralPage Using Your Stylistic ST4000 Series Tablet PC Page System States Using the Stylistic ST4000 Series Tablet PCShutting Down the System Powering UP the Tablet PCSuspending System Operation To Change StateU T I O N Power icon is blinking Suspend-to-RAMmodePower icon is not displayed Hibernate Save-to-Diskmode Using the PEN Adjusting the Display BrightnessFrom Suspend-to-RAM mode From Hibernate Save-to-Disk modeReplacing the PEN TIP Installing a PEN TetherCalibrating the PEN I N T Charging the BatteryRemoving and Installing the Battery PC Card Slot Tips for Conserving Battery PowerModem Connection Installing a Memory Module Removing and Installing Memory ModulesTo install a Dimm module in the Tablet PC Removing a Memory ModuleCare and Maintenance Page Protecting the Display Screen Care and MaintenanceTroubleshooting Cleaning the Display ScreenStoring the Tablet PC Avoiding OverheatingTablet PC is Not Responding to the Pen Speaker/Headphone Volume Too LowConfiguring Peripheral Interfaces Page Specifications Page Physical Specifications Stylistic ST4000 SpecificationsDisplay Specifications Interface SpecificationsAdditional Specifications Power SpecificationsEnvironmental Specifications Agency Notices Page FCC Registration Number Regulatory InformationE R T I S S E M E N T Avis Aux Utilisateurs Du Réseau Téléphonique CanadienFor Authorized Repair Technicians Only UL NoticeR N I N G S System DisposalPage Appendix Page Regulatory Notes and Statements FCC Regulatory InformationFederal Communications Commission statement FCC Interference StatementCharacteristics of the Device Before Using this DeviceWireless LAN Modes Using this Device How to Handle This DeviceSetting Parameters Connecting Windows 2000 SystemsWhen you finish your entry, click Apply WorkflowTCP/IP Settings Network SettingsEncryption Key Setup Network Connection WindowsSharing Setting File and Printer Sharing for Microsoft NetworksChecking the full computer name and workgroup Sharing Files Accessing Another ComputerPrinter Sharing Checking the ConnectionChecking connectivity Connecting Windows XP SystemsOn Wireless Network Connection Properties, click General Network SettingsNetwork Connection Click OKSharing Setting computer name and workgroupTransfer data for send Tx and receive Troubleshooting Table Windows XP Click Start All Programs Accessories Windows 2000 Click Start Programs AccessoriesYou want to store the IP address Click Enter, then go to the location you specified above.Windows Problem Possible CauseSetting IP Addresses Problem Possible Cause Possible SolutionAbout IP Addresses Windows XPVCC SpecificationsPage Battery gauge Battery gauge icon Battery icon Battery pack Adjusting the display brightness Air flow vents , 6Battery power Battery release latchPower on/suspend/resume Button Power usage Pen tether Peripheral connectorsSolving problems Speaker Speaker/headphone volume too low Stylistic ST4000 specificationsSystem interface connector Y l i s t i c S T 4 0 0 0 S e r i e s T a b l e t P C