Fujitsu FMW4503TS128A01 manual Peripheral Interface Specifications, Usb

Peripheral Interface Specifications

Specifications for peripheral interfaces on the Stylistic 3500 pen tablet are given in Table 5-5.For specifications on peripheral interfaces provided by the port replicator, see “Port Replicator Specifications” later in this chapter. Also note that pin assignments and other details for peripheral interfaces on the Stylistic 3500 pen tablet are given in Chapter 6 of this manual.

Table 5-5. Peripheral Interface Specifications

Feature	Specification	Comments
PC Card Slot	One Type II PCMCIA CardBus slot.	Supports CardBus and PCIC (PC Card I/O
	Compliant with PC Card Standard Rev. 3.0	Cards)
IDE Interface	Supports one IDE hard disk drive (2.5 inch)	IDE hard disk drive is preinstalled at factory.
Modem Port	RJ-11 connector for internal modem	See “Internal LAN/Modem Specifications” on
		page 44 for more information. Note that the
		LAN portion of the device is accessible only
		via the mini-dock.
Serial Port	Standard 9-pin connector that allows you to
	connect an external serial device.
Universal Serial Bus	One USB Series A receptacle on pen tablet.
Port (USB A)
IrDA Port	Infrared transceiver built into pen tablet.	Compliant with IrDA Standard Revision 1.1
		Supports: FIR (4 Mbps max),
		SIR (115 Kbps max)
		Range: approximately 1 M, 15 degrees from
		center
Infrared Keyboard	Infrared receiver built into the pen tablet for	Proprietary Fujitsu receiver.
Port	use with an optional infrared keyboard.	Range: approximately 1 M, 15 degrees from
		center
DC Power Input	16 VDC ±10%, 3.36 A	External power can be connected to DC
	Connector vendor: Hosiden	input connector on the pen tablet, mini-dock,
	(Hosiden part number HEC3900-01-010)	port replicator, or high-usage contacts. See
	This connector is a EIAJ-RC5320A standard	“DC Power Inputs” on page 67 for more
	connector.	details.
Audio Jacks	Monaural microphone input mini jack	Standard 3.5 mm mini jacks.
	Stereo headphone output mini jack	See “Audio Jacks” on page 59 for details on
		audio inputs and outputs.
System Interface	200-pin connector	For use with Stylistic 3500 port replicator or
Port		mini-dock.
High-Usage	8-position external contact connector	See “High Usage Contacts” on page 47 for
Contacts	provides connections for: DC power input and	signal assignments of the high-usage
	USB.	contacts.
Floppy Disk Drive	26-pin floppy disk drive connector	For use with Fujitsu floppy disk drive.
Port

Peripheral Interface Specifications 41