Fujitsu FMW4503TS128A01 manual Register Table, Reg Function Units Default Range

S Register Table

Default is North America. The shaded portions of the table are stored with AT&W command.

	Reg		Function		Units	Default	Range
*
	S0	Auto answer ring number			Rings	000	000-255
							*JP000-015
	S1	Ring counter. Read only.			Rings	000	000-255
	S2	Escape character			ASCII	043	000-128
**	S3	Carriage return character (CR)			ASCII	013	000-127
**	S4	Line feed character (LF)			ASCII	010	000-127
**	S5	Backspace character (BS)			ASCII	008	000-032
*	S6	Wait time for dial tone.			sec	002	002-065
						*JP	*JP004-065
						004
*
	S7	Wait time for dial tone.			sec	050	001-255
							*JP035-059
*	S8	Pause for dial delay modifier “,”.			sec	002	002-065
*	S10	Carrier loss Disconnect time.			100ms	020	001-255
*	S11	DTMF Dialing speed.			1ms	095	050-150
							*JP70-150
	S12	Escape prompt delay.			20ms	050	000-255
	S14	General bit mapped options status. (Read only)
		0:	Enable short form result codes	ATV0			Bit 3
		1:	Enable long form result codes.	ATV1		3
		0:	10PPS	AT&P0,		3	Bit 6
				&P1
		1:	20PPS	AT&P2
	S21	General bit mapped options status (Read only)
		0:	DTR behavior.	AT&D0			Bits 4, 3
		1:	DTR behavior.	AT&D1
		2:	DTR behavior.	AT&D2		3
		3:	DTR behavior.	AT&D3
		0:	DCD behavior.				Bit 5
		1:	DCD behavior.

“*” : These S-registers are country-specific.

“**” : These return to default value by &W command

“*JP” : Default for Japan mode

S Register Table 87