Cleaning the Exterior
The exterior surfaces of the printer may be cleaned with a
Cleaning the Interior
Remove any accumulated dirt and lint from the interior of the printer using a soft bristle brush and/or vacuum cleaner.
Cleaning the Printhead and Platen Roller
Inconsistent print quality, such as voids in the bar code or graphics, may indicate a dirty printhead. For best results, perform the following cleaning procedure after every roll of ribbon.
NOTE: The printer can remain on while you are cleaning the printhead. In this way all label formats, images, and all temporary parameter settings stored in the printer's internal memory will be saved.
To clean the printhead, refer to Figure 23 and follow these steps:
1.Open the printhead assembly.
2.Remove the media and ribbon (if loaded).
3.Using a swab soaked in the
4.Manually rotate the platen roller and clean thoroughly with solvent and a swab.
5.Brush/vacuum any accumulated paper lint and dust away from the media and ribbon paths.
6.Reload media and/or ribbon, and close the printhead assembly.
56 | Zebra Z4M Printer User’s Guide |