Getting Started
Figure 9 Ribbon Loading Diagram
Loading the Ribbon
To load ribbon, see Figure 9 and follow the procedure below.
Note: Use ribbon that is wider than the media. The smooth backing of the ribbon protects the printhead from wear and premature failure due to excessive abrasion.
For Direct Thermal Print Method, ribbon is not used and should not be loaded in the printer when performing the Media Calibration.
1.Adjust the Ribbon Supply Spindle position for normal or low tension. (see page 11).
2.Align the blades on the two sections of the spindle as shown in Figure 8. (You do not need to do this if your ribbon width is 2.4" (60 mm) or less.)
3.Place the ribbon roll on the Ribbon Supply Spindle.
4.Open the Printhead by moving the Head Open Lever counterclockwise to the OPEN position.
5.Thread the ribbon as shown without creasing or wrinkling it. Wind the ribbon onto the Ribbon Takeup Spindle for several turns in a clockwise direction.
6.Close the Printhead by moving the lever clockwise to the CLOSED position.
Ribbon Removal
Cut the ribbon where it is stretched between the Upper Ribbon Guide Arm and the Takeup Spindle. To remove ribbon from the Takeup Spindle, press the Release Button and slide the ribbon off the Spindle.
12