Zebra Technologies RW 420 manual Zebra Bluetooth Radio 2.0 RW-ZBR4 RW 220 and RW

Zebra Bluetooth Radio 2.0 RW-ZBR4 (RW 220 and RW 420)

Caution • Exposure to Radio Frequency Radiation. The radiated output power of this internal Bluetooth radio is far below the FCC radio frequency exposure limits. The internal Bluetooth radio operates within guidelines found in radio frequency safety standards and recommendations. Do not use the printer in an unauthorized manner.

Note • The following section only applies when an RW-ZBR4 (FCC ID: I28MD-ZBR4RW) Zebra Embedded Bluetooth 2.0 Radio is installed in a RW 220 or RW 420 printer. Unless specified elsewhere in this manual, the antenna used for this transmitter must not be co- located or must not operate in conjunction with any other antenna.

European Regulatory Information for this Radio

This device is intended for use in all EU and EFTA member states.

Europe – EU Declaration of Conformity

This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove presumption of compliance with the R&TTE Directive 1999/5/EC:

• EN55022

European Immunity Standard

• EN 60950-1

Safety of Information Technology Equipment

• EN 300 328-2 )

Technical requirements for spread-spectrum radio equipment

• EN 301 489-1/-17

EMC requirements for spread-spectrum radio equipment.

This device is a 2.4 GHz wireless LAN transceiver, intended for indoor home and office use in all EU and EFTA member states.

Important Notice:

This device is a portable RF printer intended for commercial and industrial use in all EU and EFTA member states.

34

RW Series User Guide