Nortel Networks 8010co manual Figures

		11
Figures
Figure 1	Breaker interface panel	19
Figure 2	Front panel components	20
Figure 3	Shelf circuit breakers	21
Figure 4	Alarm module display panel	22
Figure 5	Back panel components	24
Figure 6	Shelf alarm connections (upper and lower shelves)	25
Figure 7	Configuring multiple BIPs to aggregate office alarms	26
Figure 8	Configuring standalone BIPs to report alarm status	27
Figure 9	Power terminal block	28
Figure 10	Power and grounding example	29
Figure 11	Opening the front panel	30
Figure 12	Accessing the alarm module	31
Figure 13	Default jumper settings	31
Figure 14	8010co chassis configuration with BIP option	32
Figure 15	Contents of the BIP shipping container	34
Figure 16	Removing the plastic back cover from the BIP	37
Figure 17	Installing the BIP in the rack	37
Figure 18	Removing the 8010co chassis bottom 312096-A bezel	39
Figure 19	Location of power supplies	40
Figure 20	Loosening the power supply retaining screws	41
Figure 21	Disconnecting the power supply from the chassis backplane	41
Figure 22	Removing the plastic safety cover from the power supply	42
Figure 23	Power supply input and ground stud location	42
Figure 24	Power supply cables	43
Figure 25	Attaching the ground lead	43
Figure 26	Attaching the positive lead	44
Figure 27	Attaching the negative lead	45
Figure 28	Replacing the plastic safety cover on the power supply	45
Figure 29	Replacing the power supply	46

Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis