Nortel Networks 8010co manual Go to the next section, Installing shelf alarm cables on

60Chapter 2 Installation

2Replace the 8010co chassis bezel.

a Set the notch (on both ends of the 312096-A bezel) into the tabs on the chassis (Figure 42).

b Lift the top of the bezel up, and then align the captive screws with the holes in the chassis.

c Using a Phillips screwdriver, tighten the 2 captive screws to secure the bezel to the chassis.

d Replace the bezel on the second chassis, if installed.

Figure 42 Replacing the 8010co chassis 312096-A bezel

Bottom bezel

10434FA

3Go to the next section, “Installing shelf alarm cables” on page 61.

312755-G Rev 00