Transcend Information TS1G-32GCF133 dimensions TS1G~32GCF133

Page 31

TS1G~32GCF133

133X CompactFlash Card

 

 

 

Data-In Burst Host Termination Timing), and tLI indicate sender-to-recipient or recipient-to-sender interlocks, i.e., one agent (either sender or recipient) is waiting for the other agent to respond with a signal before proceeding. tUI is an unlimited interlock that has no maximum time value. tMLI is a limited time-out that has a defined minimum. tLI is a limited time-out that has a defined maximum.

2)80-conductor cabling shall be required in order to meet setup (tDS, tCS) and hold (tDH, tCH) times in modes greater than 2.

3)Timing for tDVS, tDVH, tCVS and tCVH shall be met for lumped capacitive loads of 15 and 40 pF at the connector where the Data and STROBE signals have the same capacitive load value. Due to reflections on the cable, these timing measurements are not valid in a normally functioning system. 4)For all modes the parameter tZIORDY may be greater than tENV due to the fact that the host has a pull-up on IORDY- giving it a known state when released.

5)The parameters tDS, and tDH for mode 5 are defined for a recipient at the end of the cable only in a configuration with a single device located at the end of the cable. This could result in the minimum values for tDS and tDH for mode 5 at the middle connector being 3.0 and 3.9 ns respectively.

Notes: 1) All timing measurement switching points(low to high and high to low) shall be taken at 1.5 V.

2)The correct data value shall be captured by the recipient given input data with a slew rate of 0.4 V/ns rising and falling and the input STROBE with a slew rate of 0.4 V/ns rising and falling at tDSIC and tDHIC timing (as measured through 1.5 V).

3)The parameters tDVSIC and tDVHIC shall be met for lumped capacitive loads of 15 and 40 pF at the IC where all signals have the same capacitive load value. Noise that may couple onto the output signals from external sources has not been included in these values.

Transcend Information Inc.

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Dimensions Placement FeaturesDescription Transcend Block Diagram Pin Assignments and Pin Type TS1G~32GCF133 133X CompactFlash Card Signal DescriptionDir Signal Name Dir Pin Description Inpack Iowr VCC Wait TS1G~32GCF133 Electrical SpecificationOutput Drive Type Output Drive Characteristics Signal Interface Pull-up pin 45 BVD2 to avoid sensing their batteries as Low TS1G~32GCF133133X CompactFlash CardSeries termination required for Ultra DMA operation Ultra DMA Electrical RequirementsTable Typical Series Termination for Ultra DMA Ultra DMA Mode Cabling Requirement Attribute Memory Read Timing Specification TS1G~32GCF133 Common Memory Read Timing Specification Common Memory Write Timing Specification Input Read Timing Specification TS1G~32GCF133 Output Write Timing Specification TS1G~32GCF133 True IDE PIO Mode Read/Write Timing Specification TS1G~32GCF133 Table Ultra DMA Data Burst Timing True IDE Ultra DMA Mode Read/Write Timing SpecificationTS1G~32GCF133 TS1G~32GCF133 TS1G~32GCF133 TS1G~32GCF133 Multiple Function CompactFlash Storage Cards Card ConfigurationAttribute Memory Function Attribute Memory FunctionConfiguration Option Register Base + 00h in Attribute Memory TS1G~32GCF133 Pin Replacement Register Base + 04h in Attribute Memory Socket and Copy Register Base + 06h in Attribute Memory Transfer Function Table Pcmcia Mode I/O FunctionTable Common Memory Function Common Memory Transfer FunctionTrue IDE Mode I/O Transfer Function Metaformat Overview CF-ATA Drive Register Set Definition and Protocol Table Primary and Secondary I/O Decoding Primary and Secondary Address ConfigurationsTable Contiguous I/O Decoding Contiguous I/O Mapped AddressingMemory Mapped Addressing True IDE Mode AddressingData Register Address 1F0h170hOffset 0,8,9 CF-ATA RegistersCylinder Low LBA 15-8 Register Address 1F4h174h Offset Feature Register Address 1F1h171h Offset 1, 0Dh Write OnlySector Count Register Address 1F2h172h Offset Sector Number LBA 7-0 Register Address 1F3h173h OffsetTS1G~32GCF133 Device Control Register Address 3F6h376h Offset Eh Card Drive Address Register Address 3F7h377h Offset Fh LBA CF-ATA Command SetDefinitions Check Power Mode 98h or E5h Erase Sectors C0h Execute Drive Diagnostic 90hFormat Track 50h Flush Cache E7hIdentify Device Ech Word Default Total Data Field Type InformationTotal Data Field Type Information Word 6 Default Number of Sectors per Track Word 0 General ConfigurationWord 1 Default Number of Cylinders Word 3 Default Number of HeadsWords 10-19 Serial Number Word 49 Capabilities Bit 13 Standby TimerPIO Data Transfer Cycle Timing Mode Words 7-8 Number of Sectors per CardWord 64 Advanced PIO transfer modes supported Multiple Sector SettingTotal Sectors Addressable in LBA Mode Multiword DMA transferWord 68 Minimum PIO transfer cycle time with Iordy Words 82-84 Features/command sets supportedWord 88 Ultra DMA Modes Supported and Selected Words 85-87 Features/command sets enabledWord 128 Security Status Bit 8 Security Level Word 91 Advanced power management level valueWord 160 Power Requirement Description Word 89 Time required for Security erase unit completionAdditional Requirements for CF Advanced Timing Modes Value Maximum PIO mode timing selectedValue Value Maximum Memory timing mode Supported Value Maximum Pcmcia IO timing mode SupportedIdle 97h or E3h Initialize Drive Parameters 91h Idle Immediate 95h or E1hNOP 00h Read DMA C8h Read Long Sector 22h or 23h Read Buffer E4hTS1G~32GCF133 Seek 7Xh Set Features EFh Feature Supported TS1G~32GCF133 Translate Sector Information Standby Immediate 94h or E0h Translate Sector 87hWear Level F5h Write Buffer E8h Write DMA CAh TS1G~32GCF133 TS1G~32GCF133 Error Posting Smart Command Set Smart Feature Register Values Smart Command SetDecription Smart Data Structure

TS1G-32GCF133 specifications

Transcend Information, a leading manufacturer of storage and multimedia products, offers a range of high-performance memory solutions. One prominent product is the TS1G-32GCF133, a compact and reliable CompactFlash (CF) card designed for various applications, from professional photography to industrial use and embedded systems.

At the heart of the TS1G-32GCF133 is its 32GB storage capacity, which provides ample space for storing high-resolution images, videos, and data files. This capacity meets the demands of both casual users and professionals requiring significant storage for their content. The card adheres to the CompactFlash Association's CF Type I specifications, ensuring compatibility with a wide range of devices, including DSLRs, camcorders, and even embedded systems.

One of the standout features of this model is its impressive transfer speed. The TS1G-32GCF133 boasts a read speed of up to 133x, which translates to around 20MB/s. This relatively high-speed performance is critical for users who need quick access to data, especially when capturing bursts of images or recording video. The card's write speed, while somewhat lower, ensures that data can still be written effectively without significant delay, making it suitable for various recording scenarios.

Transcend has implemented advanced technologies in the TS1G-32GCF133 to enhance both performance and reliability. The use of SLC (single-level cell) technology in some areas ensures greater endurance and stability, which is particularly important in professional applications where data integrity is paramount. Additionally, the card is equipped with built-in ECC (Error Correction Code) functionality, which detects and corrects potential errors during data transfer, further safeguarding the stored information.

Physical durability is another critical aspect of the TS1G-32GCF133. This CompactFlash card is designed to withstand harsh conditions, making it suitable for use in demanding environments. Its robust construction is resistant to shock, vibration, and extreme temperatures, providing peace of mind for users who need reliable performance in the field or in industrial settings.

In terms of compatibility, the TS1G-32GCF133 supports both the CF5 and CF6 standards, allowing it to work seamlessly with a wide range of devices. The card is also backward compatible with older CF devices, making it a versatile choice for those upgrading their storage solutions.

In conclusion, the Transcend Information TS1G-32GCF133 stands out as a reliable and high-performance CompactFlash card that meets the needs of diverse users. With its substantial storage capacity, impressive transfer speeds, advanced technologies, and robust design, it serves as an ideal solution for professionals and enthusiasts alike who seek performance and reliability in their memory storage.
Top Page Image Contents