Miller Electric Renegade 180 manual Gun Specifications, Dimensions, Weights, And Operating Angles

. Complete Parts List available at www. MillerWelds.com

4-3. Gun Specifications

Ref. 800 797-D

Air-Cooled Welding Guns For GMAW And FCAW Welding

.Using gasless flux cored wire reduces gun duty cycle.

M-15 Feeds .023 To .045 in. (0.6 To 1.1 mm) Hard Or Flux Cored Wires

.045 in. (1.1 mm) wire requires liner change to MILLER Part No. 194012 in addition to contact tip change Duty Cycle Rating:

100%: 150 A With CO2 Shielding Gas; 120 A With Mixed Gases

60%: 200 A With CO2 Shielding Gas; 150 A With Mixed Gases

Weight With 15 ft (4.6 m) Power Cable: 6.0 lb (2.7 kg) Identified With zz On Power Cable

4-4. Dimensions, Weights, And Operating Angles

	Dimensions
Height	31 in (787 mm)
Width	32 in (813 mm)
Length	41 in (1041 mm)
A	31-5/8 in (803 mm)
B	10-9/16 in (268 mm)
C	13-25/64 in (340 mm)
D	22-3/4 in (577 mm)
E	1-9/16 in (40 mm)
F	19-5/8 in (498 mm)
G	13/32 in (10 mm) Dia.
	Weight

275 lb (125 kg) Recoil Start

307 lb (140 kg) Electric Start

Optional Lifting Eye

Weight Rating

430 lb (195 kg)

NOTICE − Optional lifting eye may not be installed on units with optional cylin- der rack.

D

B

A

C

		G 4
		Holes
E	F
	Engine End	803 403

Do not exceed tilt angles or engine

could be damaged or unit could tip.

Do not move or operate unit where it could tip.

15°	15°
15°	15°
	804 476-C

4-5.	Volt-Ampere Curves
	40										This welding power source can be
											powered by the unit engine or utility
	35										power via a wall receptacle.
	30										The volt-ampere curve shows the
Voltage											minimum and maximum voltage
	25					Wall Maximum					and amperage output capabilities of
											the unit. Curves of all other settings
											fall between the curves shown.
DC	20
	15								Generator
					Wall Minimum
	10								Maximum
	5
	0
	0	20	40	60	80	100	120	140	160	180	200
						DC Amperage
											233 243

OM-228 042 Page 13