. Complete Parts List available at www. MillerWelds.com
Tighten
WOOD
1
2
3
4
1Wire Spool
2Welding Wire
3Inlet Wire Guide
4Pressure Adjustment Knob
5Drive Roll
6Gun Conduit Cable
Lay gun cable out straight. Open pressure assembly.
Pull about 6 in. (150 mm) of wire off spool. Hold tightly to keep it from unraveling. Cut off end.
Pull wire through guides into gun; continue to hold wire tightly.
Be sure wire is positioned in proper feed roll groove. Close and tighten pressure assembly. Let go of wire.
Use pressure indicator scale to set desired drive roll pressure. Begin with a setting of 3. If necessary, make additional adjustments after trying initial setting.
Remove gun nozzle and contact tip.
Turn power on.
Press gun trigger until wire comes out of gun.
Be sure that tip matches wire diam- eter. Reinstall contact tip and nozzle.
Feed wire to check drive roll pres- sure. Tighten knob enough to pre- vent slipping. Cut off wire.
Close door.
