Miller Electric Renegade 180 manual Specifications, Symbol Definitions, Description

. Complete Parts List available at www. MillerWelds.com

SECTION 3 − DEFINITIONS

3-1. Symbol Definitions

	Engine Choke	Read Operator’s	A	Amperes	V	Volts
		Manual
	Engine Oil	Fuel		Circuit Protector		Engine
	Positive	Negative		Alternating Current		Output
				(AC)
h	Hours	Direct Current		Time		Protective Earth
		(DC)				(Ground)
	Off	Temperature		Input		Single-Phase 230
						Input Volt Power
	Wire Speed	GMAW Gun		Shielding Gas		Over Temperature
		Trigger		Input
	Spool Gun

SECTION 4 − SPECIFICATIONS

4-1. Description

This unit is an engine driven welding power source/wire feeder with auxiliary power capability. The welding power source/wire feeder can also use utility power to provide weld output (no auxiliary power available in this mode).

4-2. Weld, Power, And Engine Specifications

Rated Welding	Amperage	Maximum Open-	Amperes Input at				Generator		Fuel
			Rated Load Output						Capacity
		Circuit Voltage				KVA/KW		Engine
Output	Range		230 V, 60 Hz,				Power Rating
		DC
			Single-Phase
							Single-Phase,	Kohler CS10
								Air-Cooled,
							5.0 kVA/kW
135 A @ 22.5						4.60 KVA	(Peak)	One-Cylinder,	1.8 Gal
Volts DC, 30%							4.5 kVA/kW	Four-Cycle,
	30 − 180	35	19.5						(6.9 L)
Duty Cycle At 60						3.75 KW	(Continuous)	10 HP (300 CC),
									Tank
Hz Input							40/20 A,	Gasoline Engine
							120/240 V AC,	(Recoil or Electric
							60 Hz
								Start)
	Solid/	Flux Cored				Wire Feed Speed Range
	Stainless
Wire Type
	.024 − .035
And Dia
	in.	.030 − .045 in.			40 − 720 IPM (1.0 − 18.3 m/min) At No Load
	(0.6 − 0.9	(0.8 − 1.2 mm)		20 − 700 IPM (0.5 − 17.8 m/min) Feeding Wire
	mm)

OM-228 042 Page 12