American Power Conversion 240 VAC, 8000 VA, 220 VAC, 10000 VA user manual Ethernet Port

CIRCUIT BREAKERS

8000/10000 VA	The input circuit breaker must be switched on for the UPS to operate.
	The input circuit breaker protects the UPS from extreme overload
	conditions.
Input Circuit
Breaker
8000/10000 VA	IEC 320-C13
Output Circuit	10 A total current	IEC 320-C19
	from four
Breakers		16 A for each
	receptacles
		receptacle
BASIC CONNECTORS
	Power management software and interface kits can be used with the UPS.
Serial Com	Use only interface kits supplied or approved by APC.
	Any other serial interface cable will be incompatible with the UPS
	connector.
	Connect the UPS to the network using the Network Management Card.
Ethernet Port
	Emergency Power Off terminal allows the user to connect the UPS to the
	central EPO system.
EPO Terminal
	The UPS features a transient voltage surge-suppression (TVSS) screw for
	connecting the ground lead on surge suppression devices such as telephone
TVSS Screw
	and network line protectors.
	When connecting grounding cable, disconnect the unit from the utility
	power outlet.
	External battery packs must be connected to these connectors located on
	the rear panel of the unit.
External Battery
Pack Connectors

4