APC BC300 manual Alarms and Events, Silencing the Audible Alarm, Displaying the Alarm Log

Page 13

Alarms and Events

5.0 Alarms and Events

Alarms are indicated by a red light (above the left-hand corner of the display) and a 30-second acoustic signal. An alarm is registered in the alarm log as long as it is present.

All alarms are also registered in an event logger and remain there in a stack with room for 250 events. The events are stored in order of occurance, with the latest event appearing first.

5.1Silencing the Audible Alarm

To silence the audible alarm, press

The audible alarm will automatically silence itself after 30 seconds.

NOTICE!

Silencing the audible alarm does not correct the condition that caused the alarm.

5.2Displaying the Alarm Log

To find out why the UPS sounds an alarm, display the alarm log by following steps 1-4 below.

The log shows all alarms currently active. Note each alarm!

1.Press to access the alarm log.

2.Press or to move through the alarm log.

3.If you press after displaying the last active alarm, the display will read: “No further alarm.”

4.To exit the alarm log press .

 

990-1403

 

 

User Guide APC BC300 Series 40kW 208/450/480V UPS

13

Image 13
Contents Copyright 2002 APC Denmark ApS APC BC300 Series 40kW 208/450/480V User GuideUser Guide APC BC300 Series 40kW 208/450/480V UPS Safety Symbols used in this manualThank You Contents Introduction IntroductionDisplay Unit UPS Stop/Start UPS Stop/StartUPS Stop for stand-by UPS Start from stand-byOperation OperationOperation Modes Sample Display Operation Mode DescriptionOperating Modes Using the keys Key Function Using the KeysDisplaying Measurements Operation Parameter Settings Parameter SettingsAPC Technical Support before changing this Parameter SettingsAlarms and Events Alarms and EventsSilencing the Audible Alarm Displaying the Alarm LogPossible Alarms Alarm MessagesAlarm Description Action Message Alarms and Events Alarms and Events Alarms and Events Alarms and Events 990-1403 Alarms and Events Alarms and Events Alarms and Events Displaying the Events Log Log Messages Mode DescriptionMaintenance and Testing Maintenance and TestingPreventive Maintenance Check Battery Monitor TestBattery Capacity Test Maintenance and Testing Start-up and Shutdown Procedure Start-up and Shutdown ProcedureStart-up from Maintenance Bypass Shutdown ProcedureIf you have shut the loads down Move on to step Specifications SpecificationsGeneral Specifications For Users in the United States OnlyFor Users in Canada Optional Service Programs Optional Hardware and Software FeaturesOptions OptionsOn-Site Service Preventive Maintenance VisitRemote Monitoring Service External Battery Installation ServiceLife Support Policy APC BC300 Series UPS Limited Factory WarrantyWarranty How to Contact APC How to Contact APCAPC Corporate Fairgrounds Road West Kingston, RIHow to Contact APC