American Power Conversion 400, 600, 250 Storing the UPS, Storage conditions, Extended storage

Page 31

8.0Storing the UPS

8.1Storage conditions

The UPS should be covered and stored in an upright position, in a cool, dry location. The UPS should be stored with the battery in a fully charged state. This means that the UPS should be allowed to charge the battery for at least 6 hours before the UPS is switched off for storage.

8.2 Extended storage

To achieve expected run time following extended storage, the UPS should be allowed to refresh the battery for 12 hours once every 6 months in environments where the ambient temperature is -15°C to +30°C (5°F to 86°F). For extended storage in environments where the ambient temperature is +30°C to +45°C (86°F to 113°F), the UPS should be allowed to refresh the battery for 12 hours once every month.

Page29

Image 31
Contents Back-UPS Please save this manual Important safety instructionsTable of contents Remote interface IntroductionOverview Surge suppression and EMI/RFI filteringEnglish SafetySécurité Deutsch Sicherheit¡ Seguridad Load types InstallationPlacement Receiving inspectionBattery charging Connecting to the utilityConnecting your equipment to the UPS Example labels found at system equipment rear panels Test for proper operation Overloads Principles of operation Noise and surge suppression Inverter Load transfer switchBattery charger BatteryMonitoring and control electronics TransformerOperation during a utility failure Page17 Audible alarm Controls and indicatorsPower I/0 switch Test switch on units so equippedUPS monitoring PowerChute SoftwareInterface Kits Computer interface port Difficulty Difficulté Vorsicht SchwierigkeitDificultad KmjSgWh KjnndSgW TRpnW RTodji oj oRfW Troubleshooting chartPage26 Replacing the battery Obtaining Service Storage conditions Storing the UPSExtended storage Run time versus load Specifications Declaration of Conformity Life support policy Limited Warranty∗ Mailing