Options/Accessories
6.6.3Remote Display Use
The remote display is an inactive unit unable to influence the operation of the UPS: Some of the alarms visible on the internal display are also available on the remote display (See the Alarm section in the APC Silcon User Guide).
6.6.3.1Initiating the Remote Display
After having connected the supply the display will show:
Remote Display: “APC Silcon UPS”
6.6.3.2Communication Fault
Communication fault between UPS and remote display will appear in the display as follows:
“Data transmission interrupted”
6.6.3.3 Remote Display Setting
Use # Stack to select language and type of UPS connected to remote display.
Parameter | Setting | Comments |
|
|
|
Language | GB,D,F,DK, S, SF,NL, PL, CZ, | Language |
| E, P, SK, H, I |
|
|
|
|
Host | SDC charger, DP300E, 300E | Type of UPS connected to remote |
|
| display |
|
|
|
6.6.3.4Operation |
|
|
See the Operation section in the APC Silcon User Guide.
6.6.3.5Display of Measured Value
See Display of Measured Value in the APC Silcon User Guide.
Time reading not visible from the remote display.
6.6.3.6Alarms
See Alarms section in the APC Silcon User Guide.
Installation Guide APC Silcon | 77 |